Virax VAL 80 Instructions

Manual drain cleaning machine
Hide thumbs Also See for VAL 80:

Advertisement

Quick Links

INSTRUCTIONS FOR THE VAL 80 MANUAL DRAIN
CLEANING MACHINE ref.2912 00
For drains from 30 to 100 mm
We strongly recommend that you read these instructions carefully before using the drain cleaning machine.
VIRAX VAL 80. This will help you make the best and most efficient use of it.
The non-respect of these instructions may lead to personal injury and/or damaged equipment.

Safety notice

Be sure that the appliance is connected to a properly earthed mains power supply. If in
doubt check the plug before connecting. Be sure that the power cable is intact and not damaged
in anyway.
Use a correctly earthed extension lead when the machine's power cable is too short. The use of
an inferior extension lead may lead to loss in power and thus motor over-heating.
If the working area is wet wear rubber boots and glove inserts. The machine must not be
operated whilst the operator is standing in water.
This equipment is designed for operation by no more than one person.
Wear eye protection when using the machine.
Leather gloves, not fabric ones, must be worn when manipulating the cable. Fabric gloves
may be caught in the spirals of the cable as it rotates.
Neutralise or remove any chemical drain cleaning products present in the drain before starting.
Exposure to such products may injure the operator and damage the cable.
Before starting insure that the cable in the drum is neither broken nor twisted by pulling out the
cable and checking for signs of wear or breakage.
Always replace worn (twisted or broken) cables with official VIRAX spare-parts.

Cable usage table

Ø cable
6.35 and 8 mm cables must be used with drum ref: 2912 23
Ø drain (mm)
(mm)
6.35
30 to 50
8
40 to 50
9.5
50 to 75
12.7
75 to 100
Usage
Sinks, baths and shower waste
water pipes
Sinks, baths and shower waste
water pipes
Down-spouts and smaller waste
water pipes
Down-spouts and smaller waste
water pipes

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VAL 80 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Virax VAL 80

  • Page 1 We strongly recommend that you read these instructions carefully before using the drain cleaning machine. VIRAX VAL 80. This will help you make the best and most efficient use of it. The non-respect of these instructions may lead to personal injury and/or damaged equipment.
  • Page 2 INSTRUCTIONS FOR THE VAL 80 MANUAL DRAIN CLEANING MACHINE ref.2912 00 Blades There is a choice of available blades: 2912 17 arrowhead Starting tool, ideal for cutting and scraping 2912 13 spiral Starting tool, for removing objects 2912 11 Half-moon blade...
  • Page 3 INSTRUCTIONS FOR THE VAL 80 MANUAL DRAIN CLEANING MACHINE ref.2912 00 Cable stuck in the pipe The motor can be run in reverse mode to free the cable should it become stuck in the pipe. Use the following procedure: Set the motor control switch to reverse position.
  • Page 4 For your machine to function correctly, it is essential that all bearings and cables are lubricated with VIRAX 290400 specific drain cleaning machine oil. It is especially important to lubricate all moving parts when the machine is used in an environment where sand, dirt or other abrasive materials are...

This manual is also suitable for:

2912 00

Table of Contents