Installation In The Car; Operation Of The Locator Iii In The Car - Quintezz LOCATOR III User Manual

InsTallaTIon In THe caR

WHeRe To InsTall
Important!
GPS signals are received through the built-in GPS antenna (SIrF III = suitable for all
kinds of windshields, including those with metal film).
the unit can be mounted with the Velcro strip. Please make sure that the surfaces of the
Locator III and the dashboard are clean (greaseproof) for a proper adhesion.
Please also make sure that the information display is to be clearly visible to the driver and
that the device is placed horizontally for an optimal reception of the satellites!
PoWeR sUPPlY
after installation of the Locator III, plug the power cable in the 'Dc 12V' power port (7).
remove the cigarette lighter and insert the cigarette plug in this contact accordingly.

oPeRaTIon of THe locaToR III In THe caR

sWITcHInG THe locaToR III on & aUToMaTIc selfTesT
after being switched on, the Locator III will perform an automatic self test. as soon
as you hear 'FaStEN YoUr SEat BELt, QUINtEZZ SELF tESt oK', the test has been
properly performed and the display will show:
looKInG foR saTellITes
once the automatic selftest has been performed, the Locator III will try to contact the
GPS satellites. the display will show 'SrcH' (Search).
attention!
When your are using the LOCATOR III for the first time, it can take a little longer for
the device to catch the satellites. The next time it will take less than one minute.
the Locator III will stay constantly connected with 4 to 12 satellites. If the connection
is shortly cut (for example when passing through flyunders and tunnels) the display will
go to connection mode showing 'SrcH'.
Please go to www .quintezz .com, to download the newest database into your Locator III. Please also read page 8.
GB ▪