Advertisement
THE SA2000
THE SA2000 Signage Appliance
Front View
A
B
C
D
E
A
Audio jacks
B
Composite Video Input
C
S-video input
D
Power button
E
USB 2.0 (2)
Powering ON and OFF
The SA2000 is programmed to Power On automatically when power is first applied or
re-established. There is also a Power Button, located on the front of the SA2000. To turn the
SA2000 on, push and release the Power Button on the front bezel. The adjacent power LED will
be lit (blue), and the corresponding interface will be shown on the display monitor.
To turn off the device, use the software to shutdown interface provided, or unplug the
appliance.
In the event of system lockup, unplug or re-plug the power cable. Also, the Power Button may
be used to perform a reset on the device. To do that, push and hold the Power Button for at
least 4 seconds. The system will shut down and all unsaved work may be lost. Pushing on the
Power Button again will restart the device.
Server Installation
Please refer to the corresponding User Guides for software installation instructions.
Appliance Registration
After turning on the SA2000 for the first time, a screen
prompt is displayed for registering the player. If the screen
prompt is not shown, please follow the instructions below:
1.
Press and hold "Control + Shift + Space" to exit the
WCM Player software.
2.
Navigate to Start | Programs | DT Research | WCM
Player
3.
Select Register Player Again. The Player Registration
screen should appear. Fill in all fields to register. The
required information is marked.
4.
Click OK to register and connect to the WebDT Signage
Appliance Publish Server.
2
ENGLISH
Rear View
F
G
H
I
J
F
Ethernet port
G
HDMI port
H
VGA port
I
RS232 COM port
J
DC in
VESA Mounting Bracket Installation Guide for SA2000
The WebDT Signage Appliance package includes a VESA-compliant mounting bracket (1)
which mounts the SA2000 (2) onto a VESA-compatible monitor or display.
NOTE: The VESA Mounting Bracket is compatible with most displays and monitors that support
the VESA standard.
Step1:
- Locate the existing mounting holes on the monitor.
- Line the bracket holes up with the holes on the back of the
monitor, as shown to the right.
- Place the screws to hold the mounting bracket in place
and tighten the screws (do not over-tighten).
Step2:
- Remove the two M3 screws (3) originally on the SA2000
signage appliance.
- Place the SA2000 (2) on the bracket rail with the interface
ports side facing downwards so that the two mounting
holes on the appliance are aligned with the existing holes
on the rail (see picture).
Step 3:
- Apply and tighten the screws into their original locations
and make sure that the bracket and the SA2000 are
properly secured.
Memory and Storage
Depending on the base software configuration, the user may need only the internal flash
memory of the SA2000 for user's installed software and storage. The user may also supplement
storage space with USB-based peripherals such as flash disks, disk drives, etc.
Options
The SA2000 WebDT Signage Appliance is designed to work with a range of custom and off-the-
shelf options to enhance its applicability for various deployments.
* Internal mini-PCI wireless LAN (WLAN) adapters with dipole antenna
<1>
<2>
<3>
3
ENGLISH
Advertisement
