novasmart RunR III User Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

Smartband

U S E R G U I D E

runR III

Smartwatch

G B

Table of Contents

Need help?

Do you have a question about the RunR III and is the answer not in the manual?

Questions and answers

Summary of Contents for novasmart RunR III

Page 1 Smartband U S E R G U I D E runR III Smartwatch...
Page 2 G E T T I N G S T A R T E D Read this user guide carefully before using the product. lt contains important information for your safety as well as use and maintenance advice. Keep this user guide for future reference. lf this product is passed to a third party, this user guide must be included.
Page 3 ■ Charge bracelet with 5 V/ 100-2000 mA, do not use higher power supply voltage to prevent overload. ■ Do not leave the product in direct sunlight for an extended period of time. ■ Do not dispose the product in a fire. Built-in battery could explode.
Page 4 ■ The product should usually rest a finger‘s width below the wrist bone, as you would normally wear a watch. ■ This product has been classified as IP67 and is protected against the effects of temporary im- mersion in water. For diving in larger depth, the product is NOT suitable.
Page 5 Continued use, even after symptoms subside, may result in renewed or increased irritation. lf symp- toms persist, consult your doctor. Blood pressure notice ■ Blood pressure can be subjected to wide fluctua- tions in a short period of time as its level depends on many factors.
Page 6 I N T E N D E D U S E This Smartband is intended for monitoring fi tness- related metrics such as heart-rate, blood pressure, distance walked or run, calorie consumption and quality of sleep. Data measured should not be used for any medical, ambulatory or dietary reference.
Page 7 4. Blood pressure and heart rate sensors 5. Charging plates 6. Magnetic charger with USB cable C H A R G I N G ■ Plug the charging cable into the USB port on your computer or mains charger with 5 V charg- ing output.
Page 8 T U R N I N G O N A N D O F F To turn on ■ Press and hold side button for ca. 5 seconds. ■ The Smartband vibrates, turns on and a main screen with time and date is shown. ■...
Page 9 “ F U N D O P R O ” A P P For the best experience download and install the “FunDo Pro” app on the App Store, Google Play or by scanning the following QR code. Open the app and confi rm all permissions to access all features.
Page 10 ■ Open “FunDo Pro” app. ■ Go to “More” > “+Add device” and from the list of device select “runR III” with the corresponding ID number to pair with. ■ The ID number can be found in the menu of the Smartband.
Page 11 W A K I N G U P S C R E E N To preserve battery screen goes off when not in use. lt wakes up automatically when you turn your wrist towards you. To disable waking up feature or to set a specific time frame when it is disabled (e.g.
Page 12 1. Time and date screen Once Smartband and smartphone are paired, the time and date is automatically synchronized. lf the synchronization fails, open “FunDo Pro” app and tap the icon at the top left corner to synchronize manually. Battery level Bluetooth connection Current date...
Page 13 > During exercise, tap on the respective signs on the touch screen to ■ Pause training section ■ Resume training section ■ Exit training section > > T I P The heart rate measurements taken in sport mode are not synchronized with “FunDo Pro”...
Page 14 3. Pedometer, distance counter and calorie count mode Steps taken during the day, calorie burnt and distance walked or run are shown. All data is displayed in the menu “Step” of the Smartband and in the app. To view the historical data on the Smartband, go to “Step”...
Page 15 C A U T I O N Data shown are for reference only and should not be used as any medical or dietary reference. 4. Blood pressure monitor Measures your current blood pressure. One-time measurements To make a quick and one time measurement, simply go to “Health”, select the blood pressure menu “BP”...
Page 16 T I P It is important to measure the blood pressure at the same time each day such as morning and evening. 5. Heart rate monitor Measure your current heart rate. To start manual measurements, simply go to “Health” and select the heart rate menu as shown.
Page 17 Regular heart rate measurements To turn on automatic heart rate monitoring 1. Open “FunDo Pro” app and go to “More” > “Heart rate test”, set start and end time for contin- uous heart rate monitoring. 2. Set monitoring frequency. 3. Toggle to enable “Heart rate test”. 4.
Page 18 7. Receive smartphone notifi cation ■ If the Smartband is connected to the “FunDo Pro” app, make sure that the permissions for messages from the smartphone are enabled. You can confi rm permissions in the app under “More” > “App notifi cation settings”, “Call notifi - cation”...
Page 19 9. Using stopwatch ■ Go to the stopwatch menu as shown. ■ Tap start icon to start stopwatch and tap the pause icon to pause. ■ Tap to either resume or restart the stopwatch. ■ Swipe from left to right on touchscreen or press the side button on the Smartband to exit stopwatch mode.
Page 20 R E S E T TO FAC TO RY S E T T I N G S ■ Go to “Setting” on the Smartband, scroll down and select “Reset” menu to restore the factory settings of the device. >...
Page 21 D A S H B O A R D “Analysis”, the “FunDo Pro” icon in the center and “Report” allow you to view history of all measure- ments taken and data summaries.
Page 22 A P P S E T T I N G S M E N U To access settings menu open “FunDo Pro” app and go to “More” menu: Tap to connect or disconnect the device. Activate or deactivate message notifications from various apps.
Page 23 ■ Set an alarm Set alarm clock. ■ Raise hand/turn wrist detection Set screen waking up by turning your wrist. ■ Do not disturb mode Set the time for “Do not disturb”. ■ Firmware upgrade Upgrade the Smartband Firmware. ■ Unit settings Change the preferred unit for distance and temperature.
Page 24 C L E A N I N G A N D S T O R A G E ■ Turn the product off before cleaning. ■ Clean and dry the product regularly, particulary in areas in contact with the skin. Use a clean damp or anti-static cloth.
Page 25 T E C H N I C A L D A T A ■ Voltage: 5 V ■ Battery: Li-Po battery 3.7 V/170 mAh ■ Range of current: 200 mA-2 A ■ Charging port: USB2.0 ■ Weight: ca. 40 g ■ Size: ca. 245x37 mm ■ Charging time: ca. 3 h ■...
Page 26 D I S P O S A L I N S T R U C T I O N S Used electrical and electronic products must not be discarded with household waste. The presence of the WEEE symbol on the product – or its packaging serves as a reminder of this.
Page 27 Radio Equipment Directive (RED) (2014/53/EU) and other applicable Directives, hence CE mark has been attached to it: Produced in China for novasmart c/o 3e oem sports AG Flurweg 11 82402 Seeshaupt Germany © novasmart. All rights reserved.
Page 28 www.novasmart.net...