Download
Share
Print this page
  1. Manuals
  2. Brands
  3. BE Manuals
  4. Flashlight
  5. 1200 Lumen Round Headlight Set
  6. Instructions manual

BE 1200 Lumen Round Headlight Set Instructions Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
By Always Quality Plus Products
1200 Lumen Round Headlight Set
Vistit us at www.brighteyesproducts.com
You can extend the life of your light by doing a few simple things to protect it, and by
understanding how it works by following these instructions.
Your Light set should include all parts seen in picture below. If you happen to be missing anything, please
contact us so we can get it to you.

Advertisement

loading
Need help?

Need help?

Do you have a question about the 1200 Lumen Round Headlight Set and is the answer not in the manual?

Questions and answers

Summary of Contents for BE 1200 Lumen Round Headlight Set

  • Page 1 You can extend the life of your light by doing a few simple things to protect it, and by understanding how it works by following these instructions. Your Light set should include all parts seen in picture below. If you happen to be missing anything, please contact us so we can get it to you.
  • Page 2 CREE Headlight 6400mAh Battery Charger Extener Cord Head Strap Taillight Extra Taillight Batteries Mounting O-rings Velcro Straps Diffuser Lens We carry a LIFETIME DEFECT WARRANTY on the headlight, and a 1-YEAR DEFECT WARRANTY on the battery.

  • Page 3: First Things First

    Now if the battery still needs to be charged, the led indicator on the adapter will turn red. The light on the AC adapter will turn green when the battery is fully charged.

  • Page 5: Charging Recommendations

    Do not allow the charging polarity to be reversed or short-circuited. If equipment is connected during charging, equipment should be switched off. As a delayed chemical reaction can occur if a fault is present, observe the battery in a safe place for at least 15 minutes after charging is complete.
  • Page 6 2. HOOK UP THE LIGHT! Once the battery is fully charged, unplug the power charger and disconnect the cord from the battery pack. Now place the light onto the desired location on your handle bars, and wrap the 2 thick o-rings from the front clips, stretching it all the way under to the back clips.

  • Page 7: After Your Ride

    We do carry a 1-year defect warranty on the battery. Since lithium-ion batteries lose small amounts of life after each use, or while sitting idle while completely dead, the warranty will be for a full charge that lasts less than a 1- 1/2 hours in that first year.
  • Page 8 Replacing the Batteries Pull the red silicone rubber from off the back. There will be a white plastic round cover in the back of the light. Remove that cover and there will be 2- CR2032 batteries under the cap.
  • Page 9 This new LED Cree technology is a little different than the dimmer LED lights that you may be used to. This light will stay bright until the end of its charge. When it’s dead, it will ABRUPTLY turn off. To help set the correct expectations for your potential run time, here are the maximum times we have measured.
  • Page 10 Certain handlebars might be a little too thin for the O-Ring setup, allowing the light to slip a little when riding on rough terrain.

  • Page 11: Helmet Mount

    9. HELMET MOUNT If you want to use your light on your helmet you can either put the entire head strap over your helmet, or you can use just the plastice mounting piece. If you want to use the plastice mounting piece, just slip the straps off of the mount and attach it to your Use zipties or velcro straps to...