Advertisement
Quick Links
A-200 PRINTER
POWER TYPE
BATTERY TYPE
CHARGER
PAPER TYPE
PAPER WIDTH
PAPER DIAMETER
STORAGE TEMPERATURE
RELATIVE HUMIDITY
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
Printer components name:
1. Paper warehouse cover
4. Power button
7. Charge indicator
10. Battery cover
Interactive interface
1 Battery charge indicator
Battery indicator (3 blue lights) full on means battery power is full, only one light on means the battery is
about to run out, to ensure normal use, please charge the battery.
2 Error indication
The lack of paper status, or printer in abnormal state, error indicator light (red light) flashing, while the
internal buzzer to remind each 3 seconds.
3 Charge indicator
When charging the battery, charging indicator light (red, blue, double color light) shows red, when the
battery is full, charging indicator light shows blue.
Page 1 from 4
THERMAL PRINTER FOR THE
BSR-1004 ADDRESSABLE PANEL
TECHNICAL CHARACTERISTICS
Thank you for your trust in our products
Olympia Electronics - European manufacturer
2. Paper window
5. Feed button
8. COM Port *
Rechargable Lithium polymer battery
2000mAh/7.4V
9V/2A
Thermal
57.5 0.5mm
≤40mm
-10 to 50 C
o
5 to 45 C
Up to 80%
114 x 80 x 50 mm
200gr.
3 years
o
3. Power indicator
6. Error indicator
9. Supply hub
* Note on page 3.
927200002_09_001
Advertisement
Summary of Contents for olympia electronics A-200
- Page 1 114 x 80 x 50 mm TYPICAL WEIGHT 200gr. GUARANTEE 3 years Thank you for your trust in our products Olympia Electronics - European manufacturer Printer components name: 1. Paper warehouse cover 2. Paper window 3. Power indicator 4. Power button 5.
- Page 2 Preparation before use Battery installation and considerations Remove the seal from the battery contacts then put the battery in the battery holder according to Pic and close the battery cover. Note: For the first use of the battery, need to charge it full. After the battery is stored for a long time also need to charge it full, then the battery will achieve the best use effect.
- Page 3 Final connection The connection with the panel and the power supply of the printer is shown in the figure below. Basic operation 1 Start Continue to press the printer power button for 3 seconds, the printer starts. 2 Shutdown When printer is on, continue to press the printer power button for 3 seconds, the printer is powered off. 3 Print check page In Shutdown status and print paper roll are installed well, press the power button and feed button at the same time, when a little paper come, release the power button and feed button at the same time, printer...
- Page 4 Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or not the buyer the transportation cost.