Advertisement
RC Spider
Warning!
Not suitable for children under 36 months. Choking hazard. Only for use by
children over 8 years old. To be used solely under the strict supervision of adults that have
studied the precautions given in the experimental set. Hair entanglement may result if the
child's head is too close to the motorized unit of this toy. This toy contains functional sharp
point – on the component leads. Do not short-circuit the battery terminals and motors, which
may cause overheating. Do not lock the motor or other moving parts, which may cause
overheating. Use with care and only under supervision of adult.
Packaging materials are not toys. Please remove all packaging and packing tags/wires before
giving this toy to your child.
CAUTION!
Take extra care during unpacking and use.
Please take note: As an extra precaution, check this toy regularly for signs of wear or damage.
Read the instructions carefully before use, then follow them and keep them for reference.
Warning!
Do not short-circuit the battery terminals and motor, which may cause
overheating. The wires are not to be inserted into socket outlets.
Batteries required: 6 x AAA/LR03 (Not included)
IMPORTANT: Keep these instructions. DO NOT DISCARD.
Only adults should install and replace batteries.
1.
Alkaline batteries are recommended.
2.
If the device has not been used for a long time, remove the batteries.
3.
Do not use rechargeable batteries.
4.
Do not mix old and new batteries.
5.
Do not mix alkaline, standard (carbon zinc) or rechargeable (nickel cadmium) batteries.
6.
Exhausted batteries are to be removed from the toy.
7.
Non-rechargeable batteries are not to be recharged.
8.
The supply terminals are not to be short-circuited.
9.
Only batteries of the same or equivalent type as recommended are to be used.
10.
Batteries are to be inserted with the correct polarity.
11.
Do not dispose of batteries in fire, batteries may explode or leak.
12.
Batteries may explode or leak if misused.
13.
If at any time in the future you should need to dispose of this
product please note that Waste electrical products should not be
disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling
advice.(Waste Electrical and Electronic Equipment Directive)
Item No. 28114
Advertisement
Table of Contents
Related Manuals for EASTCOLIGHT RC Spider
Summary of Contents for EASTCOLIGHT RC Spider
- Page 1 Item No. 28114 RC Spider Warning! Not suitable for children under 36 months. Choking hazard. Only for use by children over 8 years old. To be used solely under the strict supervision of adults that have studied the precautions given in the experimental set. Hair entanglement may result if the child’s head is too close to the motorized unit of this toy.
- Page 2 Introduction Almost every modern home has one or more remote control device, such as television or CD player. There are two major types of remote control, depending on the transmission signal used. This RC robot uses the first type: infrared light (IR). It is commonly used for TV and home appliance control because of lower cost and it will not interfere with other radio devices.
- Page 3 Components: 1 Chassis x1 2 Transmission shaft x2 3 Short lever x4 4 Long lever x2 5 Switch cap x1 6 Circuit board x1 7 Switch x1 8 leg x6 9 Antenna part x4 10 Body frame x1 11 Body top x1 12 Long screw x6 13 Short screw x12 14 Battery box x1...
- Page 4 4. Attach the transmission shafts (2), the long lever (4) and short lever (3) to the leg (8) using the long screw (12) as shown in Fig. 5. Use the Fig. 5 screwdriver (17) to help you. The screw should be tightly attached to the shaft but still allows the leg and the levers to rotate freely.
- Page 5 Fig. 8 8. Attach the feet to the legs using the remaining short screws as shown in fig. 9. Fig. 9 9. Cover the switch (7) with the cap (5). Install the battery box (14), the switch (7) and the circuit board (6) on the chassis.
- Page 6 12. Attach the body frame (10) in step 3 onto the chassis, as shown in Fig. 14. Done! Fig. 14 13. There is a channel select switch on the circuit board and the remote Channel 1 control. The remote control must be set to the same channel (1, 2 or 3) as the robot to be able to control it.
Need help?
Do you have a question about the RC Spider and is the answer not in the manual?
Questions and answers