1. Manuals
  2. Brands
  3. unotec Manuals
  4. Diagnostic Equipment
  5. 21.0050.01.00
  6. Manual

unotec 21.0050.01.00 Manual

Obd ii scanner
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
OBD II
Product Code:
21.0050.01.00
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 21.0050.01.00 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for unotec 21.0050.01.00

  • Page 1 OBD II Product Code: 21.0050.01.00...

  • Page 2: Product Illustration

    INTRODUCTION This product is based on GSM / GPRS networks and GPS positi oning system satellite. The built-in GSM, GPS and 2.4G antenna functi ons. Insert the device into the vehicle’s OBD II port to read the data from the computer itself. You can locate and manage the car remotely via SMS or GPRS. It is easy to install and requires no cables.

  • Page 3: Supported Models

    INSTRUCTIONS OBD COMPATIBILITY This product supports the following protocols OBD: SAE J1850 PWM SAE J1850 VPW ISO 9141-2 ISO 14230-4 (KWP2000_5BPS) ISO 14230-4 (KWP2000_FAST) ISO 15765-4 (CAN500_11BIT) ISO 15765-4 (CAN500_29BIT) ISO 15765-4 (CAN250_11BIT) ISO 15765-4 (CAN250_29BIT) It applies to all vehicles that are OBDII compliant (including, but not limited to the following models). Gasoline vehicles manufactured in the United States aft er 1996.

  • Page 4: Password Change

    PLUG CONNECTOR DEVICE IN THE VEHICLE OBD The tracking device will beep aft er plugging in the vehicle’s OBD port. This means that the device is connected and turned on. Then set to ON the batt ery switch. LED GSM / GPS LED green on: No GSM signal.
  • Page 5 ATTENDANCE MANAGEMENT (MODEL B) The model B is fi tt ed with a 2.4G transmitt er and therefore can work with the service center for the automati c ma- nagement of the assistance vehicles. The content to send for the 2.4G module can be confi gured and, by default, is the IMEI. Example: send “Carid + password + space + YB888888”...
  • Page 6 NOTICE OF MAINTENANCE Send the following SMS “service + password + space + space + 365d + 10000” to establish vehicle maintenance every 10,000km or every 365 days. If everything went correctly receive the following message: “service ok”. Main- tenance noti fi cati on will be sent to authorized 15 days before the date specifi ed numbers. If the GPRS mode is acti vated, the device will inform the service center each ti me the vehicle starts.

  • Page 7: Data Logging

    LOCATOR SERVICE (LBS) / LOCATION BY CELL-ID If the device can not establish a good connecti on via GPS, the locati on is calculated using the GSM positi oning BASDA in Cell-ID or cell identi fi cati on. In this case we will receive a message with the GPS coordinates of the last known positi on and a LAC (locati on area code, based on phone towers) code.

  • Page 8: Alarm Functions

    ALARM FUNCTIONS Low battery alarm Send the SMS: “lowbatt ery + password + space + on” to acti vate it, you receive the following message: “low ba- tt ery + lati tude / longitude” authorized 2 ti mes at an interval of 15 minutes numbers when the batt ery voltage is low (less than 3,55V).
  • Page 9 Motion alarm Confi gurati on: When the device is stopped in a place for 3-10 minutes receiving the GPS signal, the user can send the next SMS. “Move + password + space + 0200” (representi ng an area with a radius of 200 meters must be put 4 digits and the unit is the meter).

  • Page 10: Sleep Mode

    CHECK IMEI Send SMS “imei + password” and receive a message with the IMEI number. SETTING THE LOCAL TIME Send the SMS: “+ space + ti me zone + password + space + ti me” will receive the following message: “ti me OK” if everything went correctly.

  • Page 11: Gprs Settings

    GPRS SETTINGS The user must send SMS from the phone to set up APN, IP and port before starti ng tracking by GPRS. Set the APN The confi gurati on of the access point names (APN) is diff erent for each country and mobile operator. In order to confi...

  • Page 12: Faults And Solutions

    WARNINGS Please follow the instructi ons below to extend the life of the device: 1. Keep the device dry. Any liquid can damage or destroy the internal circuitry and device. 2. Do not use or store in dirty and damp places. 3.
  • Page 13 Terms 1. This warranty is valid for the purchase of products UNOTEC from the purchase date if the Warranty Certifi cate is pre- sented with the original invoice or cash receipt given to the consumer by trade, and if the certifi cate Warranty completed at the time of sale specifi...
  • Page 14 IMPORTED BY Tec1 Electronics Group SA C / Isabel Colbrand 10. Offi ce 160 | 28050 Madrid | CIF: A19273234 UNOTEC and TEC1 are registered trademarks by TEC1 ELECTRONICS GROUP, SA...

Table of Contents