1. Manuals
  2. Brands
  3. Contour Manuals
  4. Bathtubs
  5. Oakmere
  6. Installation manual

Contour Oakmere Installation Manual

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

Oakmere Installation Guide.

The Oakmere is supplied with the following components:-
Bath with Left or Right Hand Door Opening – SHOWN BELOW AS LHS DOOR OPENING
Front Panel & optional End Panel
Twin Waste kit with Shallow Traps
2 x Wall fixing brackets
Other Items supplied required with contract
Thermostatic Valve TMV22( high flow rate) -MUST BE INSTALLED IN ALL CASES
Possible additional items:
Pump and flow switch. (Refer to Installation notes)
Bath/shower mixer/taps. (Refer to Installation notes.)
IMPORTANT NOTES
The bath is supplied with 4 adjustable feet fitted & has a water capacity of 200 litres (unoccupied)
which may require pump assisted taps with a flow rate of 17 litres/min minimum. Use only 22mm
pipe leads to enhance flow rate. Bath is filled only when user has entered and shut door,
consequently taps must be thermostatically controlled.
Installation is similar as for a standard bath except that twin wastes are supplied to increase
drainage rate & to ensure the bath can be drained if one waste fails. The bath should be installed
rigidly to ensure there will be no movement or sagging of the floor when bath is used.
Consideration should be given to lowering the wastes below the floor level to keep the step
threshold to a minimum to assist customer's ability to step into the bath.
If fitting in an alcove ensure the bath freely goes into position (as sideways pressure can distort
the doorway).
The Oakmere is manufactured in glass fibre. When handling, proceed with care and
caution, in particular the bath edges are more brittle than in acrylic baths.
For ease of manoeuvrability we recommend the door be removed after unpacking
the bath. The door is held in place with 'lift-off' hinges. Open the door then lift
from bath.
Wet Rooms Direct
Telephone: 01685 898110
Email: sales@wetroomsdirect.net Website: www.wetroomsdirect.net

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Oakmere and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Contour Oakmere

  • Page 1 If fitting in an alcove ensure the bath freely goes into position (as sideways pressure can distort the doorway). The Oakmere is manufactured in glass fibre. When handling, proceed with care and caution, in particular the bath edges are more brittle than in acrylic baths.
  • Page 2 Standard Fitting Guide. 1) Lift off door and lay aside. 2) Fit the wall fixing brackets to timber frame under back rim for fixing the bath to the wall. 3) Drill and affix Taps. 4) Fit wastes, overflow and shallow waste traps supplied. 5) Place bath in position and adjust to it’s minimum height.
  • Page 3 IMPROPER USE OR CARE CAN INVALIDATE THE WARRANTY. OPERATING INSTRUCTIONS The Oakmere bath features a unique 2-part folding door to allow for easier access. A latch lock and bolt are located on the left and right hand side of the doorway respectively. Simply 'slam shut' door to close and lock into position.
  • Page 4 CARE AND MAINTENANCE The Oakmere Bath is manufactured to a very high standard in G.R.P. (Reinforced Plastic) to ensure its durability and appearance is maintained over many years of use. It has a robust, smooth and warm surface which is non-porous, resistant to dirt and bacteria and easy to clean and maintain.

Table of Contents