Summary of Contents for Turf-Tec Field Scout Soil EC Meter
Page 1
(leach) salts before turf quality declines. Check your water quality or nutrient solutions using the same probe. Resolution 0.01 mS/cm. Accuracy ± 2%. Automatic temperature compensation. Includes case, calibration standards, and battery. Field Scout Soil EC Meter - ECM1-N Page 1 - www.turf-tec.com...
Page 2
8” - 12”. Wait until the meter reading stabilizes before withdrawing the probe. Taking several measurements will allow a representative average to be computed. Important: Do not touch the sensor tip with your fingers. The oils on the skin will affect the probe’s measurement accuracy. Page 2 - www.turf-tec.com...
Page 3
30 to 60 minutes after irrigation. This should ensure the soil moisture level has approximately reached field capacity. Or use the Turf-Tec Moisture Sensor and record soil moisture readings along with EC Readings.
Page 4
Procedure 1. Be sure soil is at field capacity or record moisture content reading from the Turf-Tec Moisture Sensor in percent of soil moisture. 2. Press On/Off to power up the meter. 3. Insert Stainless steel probe tip into the soil to the desired depth.
Page 6
LIMITED WARRANTY OF TURF-TEC INTERNATIONAL PRODUCTS Turfgrass Products Corporation - dba - Turf-Tec International ("Seller") warrants to the final purchaser, that all Turf-Tec International tools will be free from defects in material or workmanship for a period of one year from date of purchase. SELLER'S SOLE OBLIGATION AND YOUR EXCLUSIVE REMEDY under this Limited Warranty and, to the extent permitted by law, any warranty or condition implied by law, shall be the repair or replacement of parts, without charge, which are defective in material or workmanship and which have not been misused, carelessly handled, or improperly repaired by persons other than Turf-Tec International.
Need help?
Do you have a question about the Field Scout Soil EC Meter and is the answer not in the manual?
Questions and answers