Page 2
Apple BlueCAT will NOT work with Apple iPhones/iPads. Thank you for purchasing your new BlueCat module. We hope you enjoy many years of service. Please read the following instructions to help you get the most from your BlueCAT. For any questions not answered below, please visit http :// www .
Sealed to IP42 – Use indoors only, protect from rain Compatibility: BlueCAT connects to the CAT port of your Yeasu FT-817, FT-857 or FT-897. If you have purchased the 4800 Baud option, it will also connect to the ‘Computer’ (CAT pass-through) port of an LDG YT100 Autotuner.
Page 4
Locate the ACC/CAT port on the rear of your radio. It is an 8 pin Mini-DIN socket. Carefully line up the plug of the BlueCAT, and insert. Do not force the plug in, as this may damage it, and your radio.
Page 5
Options available are NOR/CAT/RMT used. Set it to NOR. Select menu 085 [Tuner/ATAS] Options available are Tuner/ATAS/OFF Set it to OFF. The BlueCAT should now be showing a flashing light, and you are ready to proceed to the next step.
Page 6
Connecting When you first switch on you radio, the indicator light inside BlueCat will flash. Once a Bluetooth connection has been made to the unit (pairing) this light will stay permanently lit or change pattern. This shows that the unit has successfully connected to your bluetooth enabled device (Laptop, phone etc.).
Enter the PIN 1234 PIN shows on device with device BlueCAT Unable to pair with Pairing process Switch BlueCAT off and back on and BlueCAT has times out try connecting again. after a couple of minutes Not connected Ensure plug is fully inserted into correct port.