Table of Contents
Advertisement
TIME SETTING
To set the heating time : Choose timer setting, From 5s to 15s.
The default setting is 5 seconds. Each pressure on the button will add 1 second
until 15 seconds.
Audio beep indicator is eared for different curl effects.
The longer the time the hair is held inside the curl chamber, the more defined the
curl will be.
Results will also vary according to hair type.
TEMPERATURE SETTING
There are 10 temperature setting. Select from 140°C to 230°C.
The default setting is 190°C. We recommend you always to start with the lowest
temperature and increase the level of heat if required.
CURL DIRECTION SETTING (Right/Left/Auto)
Use the curling direction control to choose an uniform or natural finish.
Select the curl direction by sliding the switch to "G" = Left or "D" = Right.
NOTE : When styling the left side of the hair, slide the switch to the left position.
When styling the right side of the hair, slide the switch to the right
position.
This ensures that the curl sits towards the face on both sides of the head and will
give a more uniform style.
For a more natural look, select the auto setting 'A'. This will alternate,
automatically, the direction after each curl.
· Plug the styler into a suitable power socket.
· Set the suitable temperature.
· The styler is ready for use when the progress bar stop
beating.
· Choose the required setting for the hair type.
· Select the curl direction by sliding the control to either
position.
Note : Ensure hair is clean, dry and combed through.
· To start, Choose a section of hair that is no bigger than
1.5cm (A).
· Put the hair into the middle of the heat shield. Then
hook the hair under the clasp of the arrow.
(B).
Press the working button to allow the hair to be
automatically taken into the curl chamber for 5s to 15s.
Depending on your choice.
8
Advertisement
Table of Contents
