elliTek IIoTA Quick Start Manual

Thank You for your purchase! You're one step closer to
securely getting your data.
Connecting Your Devices to Databases
This quick start guide is your 1-2-3-RUN instructions to connect your devices (e.g. PLCs) to
databases (e.g. SQL) in minutes.
Log-on to www.IIoTA.net

1. Power

1. Power
Unpack your IIoTA™. Locate and connect the AC power adaptor. Plug the power
adaptor into any standard grounded receptacle.

2. Install

2. Install
Before interfacing your IIoTA™, the Workbench setup software must be installed on a
local PC. This software may be downloaded online by navigating to:
https://www.IIoTA.net/resources
Download the Workbench software. Navigate to the installation file location and double-
click the executable file to begin the installation.

3. Connect

3. Connect
Ensure the IIoTA™ is connected via standard Ethernet (RJ45) cable connections (not
included). The unit is equipped with two (2) RJ45 network ports labeled ETH0 and
ETH1. The unit comes pre-configured with the following addresses:
ETH0: 192.168.1.68
ETH1: 10.10.10.10
Edge Server Appliance
Quick Start Guide
for video tutorials and in-depth manual.
elliTek,
Inc.
TM