hylite SLIMLINE ECO HEATER Assembly & Fitting Instructions

2. OPERATION
• Ensure the power cable is pushed fully into the heaters power socket before
switching power on.
• Turn the thermostat knob in a clockwise
direction until it reaches the maximum
setting (Fig.8).
• When the room has reached the desired
temperature, turn the thermostat knob
in an anti-clockwise direction just until
the appliance switches off (amber yellow light goes out)
and not beyond.
• The temperature will then be regulated and kept at a constant level by the thermostat.
• The heater is fitted with a safety device which will switch off the heater in case of accidental
overheating (please see safety notes).
• To reset, disconnect the heater from the power source for a few minutes to allow the unit
to cool down.
• Make sure that any causes of overheating, such as obstructions, are removed and plug the
appliance in again.
• DO NOT DIRECTLY EXPOSE TO WATER
Hylite tries to improve its products for the benefit of its
customers. For this reason we reserve the right to make
changes to any product at any time without notice.
Please note that this equipment and its components have
no user serviceable parts. If you experience any difficulties
installing this product please call our helpline or write to
F4 Enterprises Limited.
Fig.8
F4 Enterprises Limited
7 Abbey Square, Chester
CH1 2HU.
Tel: 01352 736120
www.f4enterprises.co.uk
SLIMLINE ECO HEATER
WITH BUILT-IN
THERMOSTAT
Assembly & Fitting Instructions