Advertisement
How to install your NeoAir Aquarium Air Pump
a.
The plug in power supply is not waterproof – this must be mounted so that it cannot fall into the
aquarium. The mains cable must be installed with a drip loop to prevent any water running down the
cable into the plug socket (see image below).
b.
The NeoAir Aquarium air pump is designed to fit in a variety of ways outside the aquarium, ensure
the air pump does not come into direct contact with water at any time when in use and also use a
check valve is present to ensure back syphoning cannot occur.
• The design enables the air pump to be installed onto the outside of the aquarium using
the bracket & sucker provided (see images 1 & 2 below).
Top tip...To optimise adhesion clean the glass or acrylic before applying the suction cup.
•
It can also be screwed to the inside of a cabinet using a screw (screw not included) by removing
the sucker from the bracket and using a large head screw (3).
•
Or it can be placed on the side next to the aquarium without the bracket using the 4 rubber
feet (4).
Top tip...Use the least amount of airline possible this ensures you get the maximum air output in the
aquarium, excess airline reduces air output.
Advertisement
Table of Contents
Summary of Contents for Interpet NeoAir
- Page 1 (see image below). The NeoAir Aquarium air pump is designed to fit in a variety of ways outside the aquarium, ensure the air pump does not come into direct contact with water at any time when in use and also use a check valve is present to ensure back syphoning cannot occur.
- Page 2 Solution 1: Check for blockages in your airline, check valve and any connectors used (blow through them to check for blockages) Solution 2: Check for kinks in the airline, this will restrict airflow. Use Interpet Aqua Air Silicone tubing to avoid kinks.
Need help?
Do you have a question about the NeoAir and is the answer not in the manual?
Questions and answers