Dahua BN441E42 Manual

BN441E42
Four-channel Network Recording Kit
UNPACKING
❶
Your system includes the following:
• 4 x Network Dome Cameras
• 4 x Hardware Packs, with:
Moun ng Template,
Expansion Bolts (3),
Self-tapping Screws (3), Hex Wrench,
Startup Guide, and So ware CD
Network Video Recorder
• 1 x 4-channel NVR, with:
Pre-installed 2 TB HDD,
12 VDC Power Supply,
Ethernet Cable, Mouse,
Hard Drive SATA Cable, HD Hardware,
Startup Guide, and So ware CD
DIMENSIONS
❹
Camera and NVR
375.0 mm
(14.80 in.)
281.50 mm
(11.10 in.)
❷
Cameras
1 Video Output
2 Power Input
❺
56.0 mm
• Ensure the wall or ceiling can support 3x the weight of the
(2.20 in.)
camera.
• If you are connec ng the IP cameras to the PoE ports of the
NVR, DO NOT connect a 12VDC power supply to the cam-
era. Power will be supplied to the camera via PoE. Proceed
directly to the next step.
CONNECTIONS
Camera Connec ons
Ethernet, RJ-45
12 VDC or PoE (IEEE 803af)
INSTALLATION
Mount and Make Connec ons
CONNECTIONS
❸
NVR Connec ons
❶ ❷ ❸ ❹ ❺ ❻ ❼
❽
1 On/Off Bu on 6
2 PoE, RJ45 (x4) 7
3 Network Switch, RJ45 8
4 USB 2.0 9
5 Audio I/O 10
INSTALLATION
❻
Waterproof the Network Connector
• Place the wide side of the rubber ring onto the end of the
network cable extending out from the camera.
• Thread the cable through the Fixing Rubber Ring and the
Waterproof Locking Cover.
• A ach the male Ethernet connector to the network cable
coming from the camera.
• Connect the other end of the waterproof connector to the
network port and rotate it clockwise to lock the network
port and waterproof connector fi rmly.
• Slide the Waterproof Locking Cover over the main body of
waterproof connector and rotate it clockwise to seal the
connec on
❾ ❿
VGA OUT
Alarm I/O
12 VDC Power IN
HDMI OUT
Ground