Advertisement
562323
05-A1
Installation Manual of Tank Trim
Installation Manual of Tank Trim
Please show the manual to final customer.
General Drawing
General Drawing
Fill water valve
Fill water washer
Plastic filter
Connect Water supply Tube
Installation
1. Installation of fill valve
Tamper proof
Upper tube
Lower tube
Take off the tamper proof,and
Pull the adjusting rod,and raise
adjust the beight by screwing the
or lower the flxed ring to the
upper and lower tube.Then fix the
desired water level.
tamper proof.
Refill tube
Adjustin
Fixed ring
Inner float
Outer float
Unscrew the locknut and
washer.Position the fill valve into
the tank,then screw the washer
and locknut.
2.The installation of flush valve
Flush valve
Screw the flush valve tight, and
make sure the fixture block and seal
washer attach on the tank wall. Put
the flapper on the flush valve .
3.Installation of push button
Washer
Loose the nut clockwise take away
the nut and the washer from the rod.
WARNING:
Do not use an in-tank type bowl cleaner in your toilet. In-tank cleaners containing chlorine(calcium
Refill nipple
hypochlorite)
can seriously damage fittings in the tank. We shall not be responsible for any tank fitting damage caused
by the
Triangle washer
use of cleaners containing chlorine(calcium hypochlorite).
We will not be liable for damages due to improper handling or installation, abuse, or alteration of the
product. We disclaims any responsibility for incidental or consequential damages.
Washer
Locknut
Attention: If the product is different from the drawing , Please take the object as right.
Adjust the angle of the flush valve,
make sure the flapper is easy to
open, and the chain is not blocked.
Nut
Connect Rod
Install the rod into the tank handle
hole.
Screw the flush valve tight, and
make sure the fixture block and seal
washer attach on the tank wall. Put
the flapper on the flush valve .
Enter the nut on the handle and tighten.
Advertisement
