Advertisement
If your remote control needs to be connected or reset for any reason,
you will need to follow the process below to pair your new remote
control unit.
Step 1.
Unplug your Emerge II unit and
wait for 60 seconds.
Step 2.
Remove the battery cover from
the back of your new Remote Control
Unit, and remove any plastic
covering the battery if present.
www.openplan.com | 844.OPS.OPS1 | sales@openplan.com | REV 5.29.19
REMOTE CONTROL PAIRING GUIDE
EMERGE II
Advertisement
Table of Contents
Summary of Contents for Openplan EMERGE II
- Page 1 Unplug your Emerge II unit and wait for 60 seconds. Step 2. Remove the battery cover from the back of your new Remote Control Unit, and remove any plastic covering the battery if present. www.openplan.com | 844.OPS.OPS1 | sales@openplan.com | REV 5.29.19...
- Page 2 Reset Light Reset Button Step 4. Plug in your Emerge II unit. The blue light on the front of the unit will begin flashing as it searches for your Remote Control Unit. Step 5. After a few seconds, the blue light should stop flashing and your unit should be paired.
Need help?
Do you have a question about the EMERGE II and is the answer not in the manual?
Questions and answers