Download Print this page

AIR GAP AG110-001 Installation Procedures

Reverse osmosis air gap

Hide thumbs

Enlarged version

4. The AG110-001 must be installed with the "C/L" line

above the sink's rim, sump, floor drain, floor grate, or

standpipe where the discharge tubing is terminated. The

AG110-001must be installed vertically. Secure

AG110-001 with provided mounting screws (See Fig 1-4).

Mounting Screws

Critical Level (C/L) marking

"C/L"

0.857"-0.900"

Fig 1-4

5. Connect 3/8" OD poly tubing from

your RO unit to AG110-001 inlet

port and 3/8" OD poly tubing from the

AG110-001 outlet port to the drain

pipe. Use provided clamps and

screws to secure tubing. (See FIG

1-5)

5/8" I.D. Poly

tubing

The 5/8 inch ID tubing fits

AG110-001 and can be used if

desired. The AG110-001 design

enables the larger tube to be

used for inlet or outlet, or to be

as part of a double-sealed

system, or to provide added

mechanical protection to the

inside tubing. (See FIG 1-6)

500 Jefferson Street, Placentia, California 92870 USA • 949-955-3928 • Email: orders@airgap.com

Clamp

3/8" O.D.

Poly tubing

3/8" O.D.

Fig 1-5

Poly tubing

Also fits

5/8" I.D. Poly tubing

Fig 1-6

Model:

AG110-001

REVERSE OSMOSIS

AIR GAP

Old Part Number:

GAP-A-RO, KIT S-A

Doc.#400-0653-003

Placentia, California

Table of Contents

Need help?

Do you have a question about the AG110-001 and is the answer not in the manual?

Questions and answers

Summary of Contents for AIR GAP AG110-001

Page 1 Placentia, California 4. The AG110-001 must be installed with the "C/L" line above the sink's rim, sump, floor drain, floor grate, or standpipe where the discharge tubing is terminated. The AG110-001must be installed vertically. Secure AG110-001 with provided mounting screws (See Fig 1-4).
Page 2 Please read the instructions once through before starting. AG110-001 INSTALLATION INSTRUCTION 1. Make sure that the flow rate output of the RO equipment meets AG110-001 flow capacity limits such as 0.3 GPM (1.1 Liters/minute). 2. Check inlet and outlet ports marking on AG110-001 body and install AG110-001 into the threaded opening of the mounting bracket as shown on FIG 1-1 (mounting options 1 and 2), for dimensions see FIG 1-2.

This manual is also suitable for:

Gap-a-ro, kit s-a