Advertisement
Installation/Operation Guide:
Unity Synchronous Data Option
Data, drawings, and other material
contained herein are proprietary to
Wegener Communications, Inc., and
may not be reproduced or duplicated in
any form without the prior permission of
Wegener Communications, Inc.
When ordering parts from Wegener
Communications, Inc., be sure to include
the equipment model number, equipment
serial number, and a description of the part.
In all correspondence with Wegener
Communications, Inc., regarding this
publication, please refer to UTY4000-007B.
First Edition: February 1999
Revised:
June 2000
PRELIMINARY
WEGENER
COMMUNICATIONS
TECHNOLOGY PARK / JOHNS CREEK
11350 TECHNOLOGY CIRCLE
DULUTH, GEORGIA 30097-1502
(770) 814-4000 FAX (770) 623-0698
R
Advertisement
Table of Contents
Summary of Contents for Wegener Unity Satellite Receiver Model Unity Synchronous Data Option
- Page 1 Installation/Operation Guide: Unity Synchronous Data Option Data, drawings, and other material contained herein are proprietary to Wegener Communications, Inc., and may not be reproduced or duplicated in any form without the prior permission of Wegener Communications, Inc. When ordering parts from Wegener Communications, Inc., be sure to include...
- Page 2 1. INTRODUCTION The Unity Sync Data option card provides an IRD with a synchronous data channel output. This data stream is carried in transport packets whose PID may be assigned in the Wegener UMX4025 at the uplink. This data appears bit-serial on either an RS422 or LVDS output port. The RS422 and LVDS can be activated one at a time or simultaneously.
- Page 3 2.2 Customer Premises Wiring Outputs supplied on two RJ45 jacks. Pins are numbered (left-to-right) 1 to 8 as seen from the open end with tab facing downward. PIN# 3. CONTROL AND STATUS INDICATIONS Note: Sync Data option card may be setup by your network and local control may be disabled. If so, only the status monitoring will be possible.
- Page 4 REPORT COMMOND is “r p.” The report will show if any sync data cards are available. The line will read as follows: Sync Data Card #(1 or 2): INSTALLED The SYNC DATA report command is “r sd.” The report will report the sync data card status in the following form: FUNCTION CURRENT SETTING RS422 OUTPUT ENABLED/DISABLED...
- Page 5 Rear UNITY4000 MOTHER BOARD STANDOFFS Pin 1 Pin 1 Pin 1 Front Figure 1. UTY4000 Sync Data Kit Installation Module 1 Module 2 Screws from blockout plate Mounting Bracket Pin 1 Screws from kit UTY4000-007...
Need help?
Do you have a question about the Unity Satellite Receiver Model Unity Synchronous Data Option and is the answer not in the manual?
Questions and answers