ASSEMBLY INSTRUCTIONS
2
1
1
Tabs
Step 2
Step 1
Insert hinge on lid (2) into outer shell (1).
Insert inner pot (4) into outer shell (1).
Lid will snap into place when assembled
Insert inner pot at an angle to fit valve
correctly.
into side opening of outer shell.
Note: To remove lid push tabs together on
outer shell, and pull lid up.
3
4
Step 4
Place basket (3) inside inner pot (4).
CALIFORNIA PROPOSITION 65
1. Combustion by-products produced when using this product contain chemicals known to
the State of California to cause cancer, birth defects, and other reproductive harm.
2. This product contains chemicals, including lead and lead compounds, known to the State
of California to cause cancer, birth defects or other reproductive harm.
Wash your hands after handling this product.
3
Safety Switch
4
1
7
Mounting
Bracket
Step 3
Slide control panel and element (7)
down onto mounting bracket (shown in
Step 2) on side of outer shell (1).
Note: The control panel is correctly attached
when the heating element is positioned inside
the inner pot. Control panel must be correctly
attached for appliance to operate.
A built in safety switch on control panel will
prevent element from heating if not mounted
properly.
10
Step 5
Insert breakaway cord (10) into connection on
outer shell (1). Make sure "This Side Up" is
shown on top for proper connection.
WARNING
1