Vaxcel T0444 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0444
WARNING:
N O T E : S . 1 B e o f e r n i
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Dry Wall Screw (A)
Wire Connector (B)
Installation Steps
Turn off the power at fuse or circuit box
1. Unscrew the set screws and ball nuts to
separate the cap from the frame.
2. Pull out the outlet wires and grounding wire
from the post. Make wire connections using
the wire connectors (B):
---The black wire from the fixture to the black
wire from the post.
---The white wire from the fixture to the white
wire from the post.
---The grounding wire from fixture to the
grounding wire from the post.
Carefully put the wires back into the post.
3. Place the frame on the post, then secure it with the dry wall screws (A).
4. Gently pull the clips upright to place the glass panels into the frame, and then press them back to secure the
glass panels. (See Fig.1 & Fig.2)
Note: The glass panel should be fastened into position as shown in Fig.3.
Frame
Pull the clip upright
Clip
Fig.1
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
s a t l l n i , g c o n s u t l o l c l a
Glass Shade
Clip
Frame
Fig.2
e e l c r t c i l a c o d e s f r o
Finial
Set Screw
Hex Nut
Ball Nut
Fixture
Fixture Wire
Wire Connector (B)
w r i n i g a n d g o r u n d n i
Bulb Type A Max.60W
Dry Wall Screw (A)
Grounding Wire
Post
Glass Shade
Clip
Clip
Fig.3
g e r q i u e r m e t n . s
Cover
Threaded Pipe
Coupling
Cap
(not included)
180928