Omni Group Intertherm BDM35 Homeowner's Care And Operation Instructions Manual

Omni Group Intertherm BDM35 Homeowner's Care And Operation Instructions Manual

35" direct vent deluxe gas appliances

Advertisement

RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE
WARNING: IF THE INFORMATION IN THIS MANUAL
IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLO-
SION MAY RESULT CAUSING PROPERTY DAM-
AGE, PERSONAL INJURY OR LOSS OF LIFE.
FOR YOUR SAFETY: Do not store or use gasoline
or other flammable vapors or liquids in the vicin-
ity of this or any other appliance.
FOR YOUR SAFETY: What to do if you smell gas:
• DO NOT light any appliance.
• DO NOT touch any electrical switches.
• DO NOT use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone.
Follow your gas suppliers instructions.
• If your gas supplier cannot be reached, call the
fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
OTL Report No. 116-F-13-4
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
HOMEOWNER'S CARE AND
OPERATION INSTRUCTIONS
DIRECT VENT DELUXE
BDM35 AND BDM35P
35" DIRECT-VENT GAS APPLIANCES
P/N 825,021M REV. F 10/2003
MODELS
BDM35
AVERTISSEMENT: ASSUREZ-VOUS DE BIEN SUIVRE
LES INSTRUCTIONS DONNÉ DANS CETTE NOTICE POUR
RÉDUIRE AU MINIMUM LE RISQUE D'INCENDIE OU
POUR ÉVITER TOUT DOMMAGE MATÉRIEL, TOUTE
BLESSURE OU LA MORT.
POUR VOTRE SÉCURITÉ: Ne pas entreposer ni utiliser
d'essence ni d'autre vapeurs ou liquides inflammables
dans le voisinage de cet appareil ou de tout autre
appareil.
POUR VOTRE SÉCURITÉ: Que faire si vous sentez une
odeur de gaz:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous servir
des téléphones se trouvant dans le batiment où
vous vous trouvez.
• Evacuez la piéce, le bâtiment ou la zone.
• Appelez immédiatement votre fournisseur de gaz
depuis un voisin. Suivez les instructions du
fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service dos incendies.
L'installation et service doit être exécuté par un
qualifié installeur, agence de service ou le fournisseur
de gaz.
BDM35P
1

Advertisement

Table of Contents
loading

Summary of Contents for Omni Group Intertherm BDM35

  • Page 1 HOMEOWNER'S CARE AND OPERATION INSTRUCTIONS DIRECT VENT DELUXE BDM35 AND BDM35P 35" DIRECT-VENT GAS APPLIANCES P/N 825,021M REV. F 10/2003 MODELS BDM35 BDM35P RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE AVERTISSEMENT: ASSUREZ-VOUS DE BIEN SUIVRE LES INSTRUCTIONS DONNÉ DANS CETTE NOTICE POUR OTL Report No.
  • Page 2: Table Of Contents

    Please read and carefully follow all of the instructions found in this manual. S'assurer que le brùleur et le compartiment des commandes sont propres. Voir les in- Please pay special attention to the safety instructions provided in this manual. structions d'installation et d'utilisation qui The Homeowner's Care and Operation Instructions included here will assure that accompagnent l'appareil.
  • Page 3: Operation/Care Of Your Appliance

    Minimum inlet gas pressure to the appliance is To ease door closure, depress the catches to WARNING: DO NOT PLACE CLOTHING 5.0 inches water column (1.24 kPa) for natural place them in their retracted position, then OR OTHER FLAMMABLE MATERIALS gas and 11 inches water column (2.74 kPa) for close the door.
  • Page 4: Variable Flame Adjustment

    CAUTION: DO NOT ATTEMPT TO TOUCH THE Variable Flame Height Adjustment Inlet Pressure Port FRONT ENCLOSURE GLASS WITH YOUR HANDS WHILE THE FIREPLACE IS IN USE. Manifold Pressure Port Maintenance The appliance and venting system should be thoroughly inspected before initial use and at least annually by a qualified service techni- cian.
  • Page 5: Maintenance Schedule

    Maintenance Schedule Annually (Before the onset of the Burning Season) Maintenance Task Accomplishing Person Procedure Inspecting/Cleaning Burner, Logs Qualified Service Technician Inspect valve and ensure it is properly operat- and Controls ing. Check piping for leaks. Vacuum the control compartment, fireplace logs and burner area.
  • Page 6: Burner Adjustments

    Refer to Figure 3 and remove the front glass 2. Position the door frame in front of the Adjustment enclosure panel as follows: firebox opening and engage the top flange over the lip at the top of the firebox opening. CAUTION: THE ADJUSTMENT ROD AND NEARBY APPLIANCE SURFACES ARE HOT.
  • Page 7: Log Placement

    Log Placement WARNING: LOGS GET VERY HOT AND WILL REMAIN HOT UP TO ONE HOUR AFTER GAS SUPPLY IS TURNED OFF. HANDLE ONLY WHEN LOGS ARE COOL. TURN OFF ALL ELECTRICITY TO THE APPLIANCE BEFORE YOU INSTALL GRATE AND LOGS. WARNING: THIS APPLIANCE IS NOT MEANT TO BURN WOOD.
  • Page 8: Wiring Diagrams

    WIRING DIAGRAMS WARRANTY REPLACEMENT PARTS Wiring diagrams are provided here for refer- Your gas appliance is covered by a limited twenty A complete parts list is found at the end of this ence purposes only. This information is also year warranty. You will find a copy of the war- manual.
  • Page 9: Accessory Components

    ACCESSORY COMPONENTS Rocker Switch Kit 80L41 Optional on Unit Rocker Switch An optional rocker switch kit can be installed Remote Control System H0250 directly on these appliances to provide for On Builder Remote Control System and Off operation in lieu of a wall switch. This kit is designed to install in the lower control (Model RCF) compartment out of view and is perfect for use...
  • Page 10 ACCESSORY COMPONENTS Brass Finish Hood Kit 14M91 FHTK35-B Brass Hood Kits Attractive hoods are available in two styles to Door Frame Kit be used on the these appliances. These hoods Brass Finish 14M92 FDTK35-B2 are designed to be fitted to the face of the Door Frame Kit appliance.
  • Page 11 TROUBLESHOOTING THE MILLIVOLT GAS CONTROL SYSTEM Note: Before troubleshooting the gas control system, be sure external gas shut off valve (located at gas supply inlet) is in the “ON” position. Important: Valve system troubleshooting should only be accomplished by a qualified service technician. POSSIBLE CAUSES SYMPTOM CORRECTIVE ACTION...
  • Page 12: Lighting Instructions

    LIGHTING INSTRUCTIONS – HONEYWELL AND SIT MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted with a piezo •...
  • Page 13 INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT HONEYWELL ET SIT POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT : SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A.
  • Page 14: Replacement Parts List

    REPLACEMENT PARTS LIST Natural Propane BDM35 BDM35P DESCRIPTION Part No. Qty. Part No. Qty. Gas Fireplace Assembly – – – – Hood LB-91941BZ LB-91941BZ Louver (Top) LB-92436BZ LB-92436BZ Louver, (Base) LB-92435BZ LB92435BZ Enclosure, Glass Front (Complete) LB-92534B LB-92534B Nameplate (Brand) 13M1301 13M1301 Latch...
  • Page 15 REPLACEMENT PARTS (In Mounting Bracket - Not Shown) NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
  • Page 16 The manufacturer reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2002 by LHP P/N 825,021M REV.

This manual is also suitable for:

Intertherm bdm35p

Table of Contents