Lock'er Down 2018 Instructions

Instructions for Model 2018
1. If you have a combination lock, it is easier to set the
combination before installing the safe.
2. Open console and remove the three screws in the floor of
console.
3. Place the front plate inside the console with the studs up but do
not attach fasteners.
4. Put the lid assembly in as shown in Fig 1, turn and pull up to top.
5. Install the flange nuts attaching the top to the front bracket to
hold the top in place.
6. With the lid open, place the back bracket to the top plate with
two flange nuts.
7. Insert the three provided screws to hold the front and rear
brackets to the console floor.
8. Now tighten the four flange nuts and you are done.
Top Assembly
Enjoy your purchase.
Front Plate
See back for USB
Extension
installation.
Rear Plate