Summary of Contents for eka CyberLock FlashLock
- Page 1 FlashLock and Key Fob Battery Replacement Field Instruction Manual Copyright © EKA CyberLock, www.ekacyberlock.com.au All Rights Reserved www.ekacyberlock.co.nz...
- Page 2 FlashLock and Key Fob Battery Key Fob Battery Replacement Use a flathead screw driver to pop the back case off the Key Fob. See Figure 1. Figure 1: Wedge off Back Case Button Case Back Case Button Pull the inner assembly out and remove the button case from the circuit board.
- Page 3 FlashLock and Key Fob Battery Key Fob Battery Replacement Press the button case down over the assembly. Make sure the lip is fully pressed into the back case to ensure a water-resistive seal. See Figure 5. Snap the top case into place. Figure 5: Set Button Seal FlashLock Battery Replacement Two LEDs...
- Page 4 11. Test the lock for functionality, verifying that the cap is locked in place and unlocks with a key fob. For further questions and assistance, please contact EKA CyberLock Support by email at ekasupport@locks.com.au or by calling AUS: 1300 722 311 or NZ: +64 (0) 9 368 4802 Figure 10: Aligning the Groove V1.0_8101 | Division of Davcor Group Pty Ltd...
Need help?
Do you have a question about the CyberLock FlashLock and is the answer not in the manual?
Questions and answers