Table of Contents
Advertisement
Safety
1
Safety
1.01
Directives
This machine is constructed in accordance with the European regulations contained in the
conformity and manufacturer's declarations
In addition to this Instruction Manual, observe also all generally accepted, statutory and
other regulations and legal requirements and all valid environmental protection regulations!
The regionally valid regulations of the social insurance society for occupational accidents or
other supervisory organisations are to be strictly adhered to!
1
General notes on safety
.02
1.
Safety symbols
03
1 - 1
This machine may only be operated by adequately trained operators and only after
having completely read and understood the Instruction Manual!
All Notes on Safety and Instruction Manuals of the motor manufacturer are to be read
before operating the machine!
The danger and safety instructions on the machine itself are to be followed!
This machine may only be used for the purpose for which it is intended and may not be
operated without its safety devices. All safety regulations relevant to its operation are to
be adhered to.
When exchanging sewing tools (e.g. needle, presser foot, needle plate, feed dog or
bobbin), when threading the machine, when leaving the machine unattended and during
maintenance work, the machine is to be separated from the power supply by switching
off the On/Off switch or by removing the plug from the mains!
Everyday maintenance work is only to be carried out by appropriately trained personnel!
Repairs and special maintenance work may only be carried out by qualified service staff
or appropriately trained personnel!
When servicing or carrying out repairs on pneumatic devices, the machine is to be
removed from the compressed air supply! The only exceptions to this are adjustments
and function checks carried out by appropriately trained personnel!
Work on electrical equipment may only be carried out by appropriately trained
personnel!
Work is not permitted on parts and equipment which are connected to the power
supply! Exceptions to this are only to be found in the regulations EN 50110.
Modifications and alterations to the machine may only be carried out under observance
of all the relevant safety regulations!
Only spare parts which have been approved by us are to be used for repairs! We
expressly point out that any replacement parts or accessories which are not supplied by
us have not been tested and approved by us. The installation and/or use of any such
products can lead to negative changes in the structural characteristics of the machine.
We shall not be liable for any damage which may be caused by non-original parts.
Danger!
Points to be observed.
Danger of injury for operating and specialist personnel!
Advertisement
Table of Contents
