Speakman BIDET REMOTE Instructions

INSTRUCTIONS FOR MODELS
BIDET REMOTE
WATER TEMP DRYER TEMP SEAT TEMP
LIGHT
For additional assistance or service please contact:
SPEAKMAN
®
800-537-2107
customerservice@speakman.com
www.speakman.com
92-BIDET-REMOTE-01
TOOLS AND SUPPLIES
Pencil Phillips
Screwdriver
Drill Drill Bit
1/4"
Measuring
Tape
IMPORTANT
SAFETY TIPS
Cover your drain to prevent loss of parts. Be sure to
wear eye protection while cutting pipe.
MAINTENANCE
Your new Speakman Product is designed for years
of trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. The use of
harsh chemicals and abrasives on any of the
Speakman custom finish products may damage the
finish and void the product warranty. Please be sure
to only use approved cleaners. Please contact
Speakman for any clarification of acceptable
cleaners.
WARRANTY
1 Year Limited Warranty
Warranty information can be found at:
www.speakman.com

INSTALLING THE WALL BRACKET WITH SCREWS

IMPORTANT! Do NOT install unit where it may come in direct contact with water.
1. Place the Remote Control Hanger upright on the
Per-determined area of the wall and mark the
location of the two mounting holes on the wall with
a pencil.
• Drill a hole in the marked position on the wall with
a 1/4" Drill Bit, with a depth of 1-3/8".
NOTE: Location of Wall Mount Bracket should be
accessible while seated on the Bidet.
2. Push the Anchors into the drilled holes and ensure
they are fully inserted and flush to the wall surface.
• Position the Wall Bracket over the Anchors and
secure into position with the included Screws. Cover
the screw heads with the included Caps.
3. Install 3 AAA batteries into the Remote Control
and replace cover.
4. Place the Remote Control into the Wall Bracket.
LIG HT