TWIG Beacon Quick Manual page 2

When the beacon is in the configuration mode, the editor (see the picture on
the left) pops up by clicking the beacon on the list.
When the "Keep on config mode" box is ticked, all beacons in configuration
mode (marked in bold on the list) remain in the configuration mode 10
minutes also when outside the configurator coverage area.
When "Keep on config mode" box is not ticked, all beacons in configuration
mode (marked in bold on the list) will remain in configuration mode for 10
minutes from start or last configuration.
If the device is not configured during the given time, the beacon must be
restarted with the jumper in the main PCB.
4. PROTOCOLS & MESSAGING
TWIG Beacon transfers its data via ISM band. The relevant data is being
transferred to system backend via MPTP messaging. Please refer to TWIG
MPTP v3.24 or later for details.
5. SAFETY & RECYCLING
Usage: -20°C to +50°C
Storage: -30°C to +70°C
Do not open the device or battery by yourself or pierce holes in it. Rough
handling may break the circuitry inside the device. Do not drop, knock,
twist or shake the device or its battery. Keep the device dry, liquids contain
minerals which could corrode electronic circuits. If the device gets wet, turn
it off and dry the device and the battery immediately. Put the device into an
upright position and let it dry. It is recommended that a dealer or service
personnel check that the device functions properly. Even though the device
is waterproof, do not wet the device unnecessarily or immerse it in water.
Protect the device from heat. High temperatures may shorten the life of
the electronical devices, melt or warp plastics and damage batteries. Do
not warm up the device or battery or use it near fire. Do not short-circuit
the battery or battery contacts. Exposing the metal strips of the battery
to a close contact with a metallic object, such as a coin, a clip or a set of
keys can cause accidental short-circuiting and damage the battery. Use
the battery only for the purpose it is intended. Clean the device with a soft
cloth, dampened slightly with mild soapy water. Do not clean the device
with harsh chemicals, solvents or other corrosive substances. Only allow
service personnel authorised by the dealer to service the device. Recycle
the batteries according to the country-specific regulations.