Advertisement
6. Place the Side Tackboard against the Writing Board
making sure the bottom of the two panels are even.
Mark the top and bottom of the Tackboard on the wall
and remove the board from the wall. Make a level line
5/8" below the top mark and 1 1/8' above the bottom
mark line. Fasten L-Brackets (B) on the leveled line
in two spots where wall studs are. See illustrations #
5, 5a and 5b.
P-7
P-7
Illustration # 5
Illustration # 6a
8. Measure the H-Bar (P-6) and use the side of Side
Tackboard (P-2) that matches the H-Bar length. One of
the four corners on back of the Side Tackboard has a
fastener. DO NOT force that side of the board into the
H-Bar Channel. After placing the correct side of the
Side Tackboard (P-2) into the H-Bar channel fasten your
board to the L-Brackets (B) by using 1/2" Self Drill
Screws (C). See illustrations # 7.
E
P-7
Illustration # 8a
P-7
A
P-6
P-1
Illustration # 6
P-7
P-2
P-1
Illustration # 8
Top mark
Level line
P-2
Level line
Bottom mark
7. Place the Right 5' H-Bar (P-6) or Left 5' H-Bar
(P-5) or both if you have type H Combo-Rite over
the side of Writing Board (P-1) frame. Make sure
notch on H-Bar falls into the end of the writing
board map rail as the arrow shows in illustration #
6. Match the bottom of Writing Board and the H-
Bar (P-4) for the right and (P-5) for the left and if
you don't have the Top Tackboard (P-7) your H-Bar
will only be 4' long using (P-4) for the right and
(P-3) for the left side of your board. Fasten the H-
bar to the wall with three 1-1/4" Screws (A). See
Illustration # 6 and 6a.
9. Insert all your map rail accessories. Use
Map Rail End (short) (D) if you have H-Bar
D
(P-6) for right, and or (P-5) for left side,
but if you don't have H-Bar (P-6) nor (P-5)
use Map Rail End (Long) (E), and fasten
P-6
them with 1/2" Self Drill Screws (C). See
illustrations # 8 and 8a.
6
B
Top mark
Level line
A
Illustration # 5a
A
Level line
Bottom mark
B
Illustration # 5b
P-7
P-1
Illustration # 7
P-6
A
P-2
Advertisement
