Table of Contents
Related Manuals for Wallach Surgical Devices ZOOMSCOPE COLPOSCOPE
Summary of Contents for Wallach Surgical Devices ZOOMSCOPE COLPOSCOPE
- Page 1 ZOOMSCOPE COLPOSCOPE INSTRUCTION MANUAL This device complies with the EC Medical Device Directive (93/42/EEC) WALLACH SURGICAL DEVICES 95 Corporate Drive Trumbull, CT 06611 USA Phone: (203) 799-2000 Fax: (800) 799-2002 IMSC006 · Rev. A · 2/08...
- Page 2 Read all safety information and instructions before using this product! CAUTIONS: • DO NOT USE IN THE PRESENCE OF FLAMMABLE ANESTHETICS. • LAMP GETS VERY HOT: DO NOT TOUCH! INTENDED USE The Wallach ZoomScope is a microscope for colposcopy. The ZoomScope has a range of magnification from 4.66x to 20x.
- Page 3 II. ARM ADJUSTMENT Your Wallach ZoomScope is adjusted and tested just prior to leaving the factory. The ZoomScope arm may be moved into any position and should remain in place. However, further arm adjustments may become necessary. A 5/64 Allen wrench is included. A.
- Page 4 NOTE: If the scope is jolted or moved across a bumpy floor before the bulb has cooled, the bulb may blow out prematurely. The replacement bulbs may be ordered from Wallach Surgical Devices (203) 799-2000, or purchased from a local camera shop. Wallach Bulb REF 906117; Tungsten Halogen Projector Lamp ESD, 150 watt, 120v.
- Page 5 V. SCOPE OPERATION A. Plug in power cord. B. Turn “ON” Master switch. C. Turn “ON” front panel light switch. D. Turn power knob to appropriate light intensity. This can be adjusted at any time during the procedure. E. Position the ZoomScope; lock casters in place. F.
- Page 6 VIDEO ZOOMSCOPE Analog Camera Setup The camera is shipped next to the microscope head in the protective box. Connect the end of the cord which is attached to the suspension arm nearest to the microscope head to the camera. Connect the other end to the camera control unit (CCU) located on the side of the light box.
- Page 7 XI. SERVICE AND REPAIR In the event your ZoomScope becomes inoperative, please make the following checks before calling the factory: 1. Check that the unit is plugged into a working wall receptacle. 2. Check for a burned-out bulb. 3. Check for a blown fuse. Bulb, optional eyepieces, etc.
- Page 8 EXPLANATION OF SYMBOLS CE Mark (for medical devices only) made in accordance with 93/42/EEC Medical Devices Directive See Instructions for Use For Professional Use Only Shock Hazard Warning Reorder Number Serial Number AUTHORIZED EUROPEAN REPRESENTATIVE: LMI Feinmechanik GmbH Leibnizstrasse 32 D-10625, Berlin GERMANY IMSC006 ·...
Need help?
Do you have a question about the ZOOMSCOPE COLPOSCOPE and is the answer not in the manual?
Questions and answers