Advertisement
Quick Links
Install Kit Contents
Card Reader 032-1011
060-1026 Cable
Hex Self Drive Screws (4)
060-1030 Cable adaptor
Install Guide 700-1030
Installation Steps
1. Unscrew the retainer screw at the bottom of the card reader and remove the back plate.
2. Position the back plate of the card reader on the vehicle surface and mark screw and center hole positions.
3. Drill out the ½" center hole and mount the backing plate with the 4 self tapping hex head screws.
4. Run the 060-1026 cable's 1x4 Microfit end through the hole from the LMU Controller and connect it to the
card reader.
© Seon Design Inc. | Mar. 2017 | All rights reserved | www.seon.com Part Number: 700-1030 R3
vMax Trac LMU Install Guide
LED Functions
Red, lit – Ready for reading
Green, lit – Reading
*700-1030*
Advertisement
Related Manuals for Safe Fleet Seon vMax Trac
Summary of Contents for Safe Fleet Seon vMax Trac
- Page 1 vMax Trac LMU Install Guide Install Kit Contents LED Functions Card Reader 032-1011 Red, lit – Ready for reading 060-1026 Cable Hex Self Drive Screws (4) Green, lit – Reading 060-1030 Cable adaptor Install Guide 700-1030 Installation Steps 1.
- Page 2 vMax Trac LMU Install Guide 5. Thread the cable connector in the hole and reattach the card reader to the back plate. 6. Turn off vehicle ignition. 7. Disconnect the 2x10 Microfit connector from the LMU Controller. 8. Connect the red wire from the 060-1030 cable to a fused ignition source. Alternately, splice it into the white ignition wire on the 2x10 Microfit cable harness.