Connecting The System Transmitter To Vcr - Optex 750830 Owner's Manual

D. Connecting the System Transmitter to VCR
1. Connect one set of audio/video(A/V) cables (or SCART cable labeled «TRANSMITTER») to the
A/V jacks of the transmitter and to the A/V output jacks (or SCART connector) on the back of your
VCR. Be sure the yellow, red and white plugs match the yellow, red and white jacks on both the
VCR and the transmitter. If the VCR has only one output for audio (mono sound only), connect the
white plug to that single audio output and to transmitter's AUDIO LEFT jack.
2. Plug one end of the power adapter into the back of the transmitter and the other end into any
230-volt wall outlet (or 120-volt). Use only the adapter provided.
Note : make sure the ON/OFF switch is in the «OFF» position before connection.
3. If your VCR has only one set of A/V output jacks and you want to use it with a nearby TV, con-
nect 75 ohm RF coaxial cable from the modulator signal OUT port on your VCR to the VHF/UHF
IN port on your TV. (Note:In order to also view cable programs on that TV, connect your incoming
cable TV source to the IN port of the VCR.)
4. Locate and orient the transmitter for best performance of transmitter.
To power outlet
Transmitter
RCA to scart cable
VCR
TV ANT IN
75Ω cable
TV
Scart cable
Notice d'utilisation du transmetteur Audio/Vidéo 2,4GHz Page 18