Related Manuals for Lafalink LF-R500U
Summary of Contents for Lafalink LF-R500U
- Page 1 2.4Ghz 150Mbps Outdoor Wireless Access Point Quick Installation Guide 2.4Ghz 150Mbps Outdoor Wireless Access Point Quick Installation Guide...
- Page 2 PoE Power Supply PoE Port: Transfer the power and data at same time Introduction LAN Port: Transfer data only through Ethernet cable Thank you for purchasing the Access Point This manual suit for quick installation of 11N Typical Network AP is used for remote point-to-point and point-to-multipoint wireless AP &...
-
Page 3: Installation Steps
Installation Steps Hardware Connection Setting the Computer POE Power Supply Access Point Log in the Web Management Turn on all your network devices and then check to see if the LEDs on the AP display normally as the diagram below describes. Setting the AP Note: 1. - Page 4 Setting the AP Double-click Internet Protocol Version 4 (TCP/IPv4). After successful login, you can see web management page of the CPE, please go to Wizard on the top menu． Select Use the following IP address, enter 192.168.0.100 into address 255.255.255.0 into the Subnet mask Click OK tions for your computer.
- Page 5 Setting the AP Two devices are needed for this application. The AP A Setting to Access Point Mode Select Access Point for the operation mode, then click Next. When a windows pops “Change operation mode, the device will be reboot, are you sure to continue?”...
- Page 6 As for AP B, you can disable the wi status of AP. then click Finished. When a windows pops “Change the LAN IP address of the system will reboot, are you sure to continue?” Please chilck the Sure. After AP is reboot successful, choose the “wireless connect” you can see the AP Signal Strength and Link Quality, that means AP B and AP A are connect with each other.
-
Page 7: Appendix I Trouble Shooting
Management Appendix I Trouble Shooting Click Management to enter into the management page as follow Symptoms Treatment Forget the login user Restore to factory default name and passwords 1 Pls make sure the PC and AP’s IP Address Can’t login AP are in same network segment, can be checked through WEB through Ping: PC start--input CMD in Run, then... -
Page 8: Appendix 3 Poe Power Supply
Appendix 2 Hotel Wireless Solution Topology Router AP Mode Repeater Mode Switch Appendix 3 PoE Power Supply The PoE power supply of Access Point, line 1.2.3.6 is using transfer the data, and 4.5.7.8 is using transfer the power, 4.5 is “+”, 7.8 is “-”. Data PoE Power Supply Power...