AGA Amana ALD10T Quick Start & Reference Manual

Quick Start Reference Guide
Refer to Product Safety Manual for Safety Statements
PROGRAM DEFROST
1
2
3
4
5
6
7
8
9
10
QTY
CHECK
POWER
PROGRAM 2X
LEVEL
STOP/ START/
RESET +30 SEC
Complete Owner's Manual available online
A
B
So...how do I use it?

Manual Operation

To cook food using a specific entered time and power level:
1. Open oven door and place food in oven. Close door.
2. Press POWER LEVEL pad until desired power level is shown.
3. Press the number pad(s) to enter a cooking time.
4. Press START pad.
5. At end of cooking cycle oven beeps 3 times and shuts off.

Programming Items

11
This microwave oven has 20 programmable pads (1-20).
NOTE: Only pads 1-10 are preprogrammed at the factory.
12
1. Door can be in either open or closed position with :0 showing in
display.
13
2. Press PROGRAM pad.
• PROGRAM appears in display.
14
3. Press desired number pad to be programmed.
• If pad 5 is being programmed, PROG- -05 will appear in display.
15
• To program pads 11-20, press number pad twice rapidly. (ex. To
program pad 15, press pad 5 twice rapidly.)
16
4. Press POWER LEVEL pad to select desired power level.
• Press POWER LEVEL pad to change power level if desired (some
17 models).
• POWER LEVEL displays.
- 100%
18
80%, 60%
power. By continuing to press the Power Level pad, the power
19
level will cycle through each level continuously.
5. Press desired number pad(s) to program desired cooking time.
20
6. Press START/+30 SEC pad to save programming for Stage 1.
• If Stage 2 or Stage 3 is desired for programming, repeat steps 4
through 5.
• If Stage 2 or Stage 3 is not desired press STOP/RESET pad, to
end programming sequence.
NOTE: If door is closed or STOP/RESET pad is pressed before
programming is complete, changes are discarded and
microwave exits programming mode.

Oven Clearances

A—Allow at least 4" (10.2 cm) of clearance around top and
sides of oven. Proper air flow around oven cools
electrical components. With restricted air flow, oven may
not operate properly and life of electrical parts is
reduced.
B—Allow at least 4" (10.2 cm) between air discharge on
back of oven and back wall.
indicates 100% (full) microwave power,
indicates 60%, and
80% indicates
40% indicates 40% microwave