Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Caliber HCD 301I
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper uses can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. - Page 3 ALARM TIME MODE OFF/ON OFF/ON...
-
Page 4: Repeat All
1. ALARM Button .In off mode: press ALARM to set the alarm. 2. TIME Button .In off mode: press TIME to set the clock time 3. RPT/SLEEP Button . In USB/SD mode, press RPT button to select REPEAT ALL or REPEAT single track. It is defaulted at REPEAT ALL. -
Page 5: Installation
INSTALLATION INSTALLATION BATTERY BACK UP SYSTEM This unit uses 2pcs UM-4 AAA’ batteries (not included)to maintain the time and alarm settings in the event that it is accidentally unplugged, or you experience a temporary power failure. We recommend that you install a well-known brand of Alkaline battery for longest life and best performance. -
Page 6: Basic Operation
WARNING: Do not apply power to the unit until all of your connections are made. Please turn off your iPod/iPhone before docking. Check your iPod/iPhone manual for the proper procedure to turn your model off. 1. Insert the AC cord into AC wall outlet. 2. - Page 7 Alarm Setup 1. Press the “ALARM” button during power off mode to access time setup. 2. Press Alarm Button until “ ” icon flash then press button to select wake to sound source circularly (the Alarm1 and relevant alert icon: from radio, iPod, USB, Card to Buzzer with Alarm1 appeared.
- Page 8 iPod/iPhone/USB/SD is detected), the buzzer will sound instead. -if the unit is power off, the alarm will sound in Buzzer mode. -If the alarm sound in Buzzer, the sound will last 10 Minutes as Alarm. If the alarm sound in Radio/iPod/USB/SD, the sound will last 1 hours.
- Page 9 Recalling Stored Preset Stations -Press button on the unit, the memory channel number ”01” will flash, press again to select the channel number you desire station. iPod/iPhone Docking -Dock your iPad, iPhone or iPod through the iPod dock connector. Note: - Please be careful when seating the iPad/iPhone/iPod into the docking to avoid damaging the 30-pin connector on the iPod/iPhone or in the docking system.
-
Page 10: Specifications
Symptom Possible problem Solution AC cord is not plugged into The main unit does Plug the AC cord into a wall outlet. a wall outlet. not respond (no Wall outlet is not Plug another device into the same outlet to confirm the power) functioning. - Page 11 “Made for iPod”, ”Made for iPhone”, “Made for iPad” mean that an electronic accessory has been designed to connect specifically to iPod, iPhone, iPad, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its complicance with safety and regulatory standards.