Related Manuals for Sony FJ Series
Summary of Contents for Sony FJ Series
- Page 1 1.MS-1-D.1 Confidential Chapter 1. Disassembly & Assembly Guide 1-3. Disassembly & Assembly - Main Section - MS-1 Main Section Disassembly FJ Series...
-
Page 2: Battery Pack
1.MS-1-D.2 Confidential Battery Pack Battery Pack Button (Battery) Button (Battery) Slide the Button (Battery) to UNLOCK position. While sliding the Button (Battery) to RELEASE side, remove the Battery Pack. FJ Series... - Page 3 Outspread the tabs (two places) simultaneously to release the lock and pull out the Memory in the direction of the arrow. * If there are two Memory, remove the other side of the Memory as the same procedure as above. FJ Series...
- Page 4 Remove the two screws, and disconnect the connector portion by Raise the front side of the HDD, and remove it toward the front. sliding it in the direction of the arrow. * When removing the HDD, pay attention to the convex portion. FJ Series...
- Page 5 1.MS-1-D.4(a) Confidential HDD-2 2 [ADD] 2 [ADD] Mylar Peel off the Mylar (one place). FJ Series...
- Page 6 1.MS-1-D.5 Confidential Parts of the HDD Screw: B7 Bracket (HDD-Rear) Bracket (HDD-Front) Remove the two screws each on the right and left sides. Remove the Bracket (two places). FJ Series...
- Page 7 1.MS-1-D.6 Confidential Screws (Bottom) Screw: B2 Screw securing the Keyboard Remove the 11 screws. FJ Series...
- Page 8 Raise the Keyboard toward the front. * There are detents around the F1, F5, F11, and Insert key. * The FPC is connected to the Keyboard. Lock Lever Slide the lock lever upward and release the lock. Remove the FPC upward. FJ Series...
- Page 9 4th Model [MA] Connector Remove the screw. Disconnect the connector by sliding the Optical Disc Drive in the * Except 4th Model: One place direction of the arrow, and remove the Optical Disc Drive. * 4th Model: Two places FJ Series...
- Page 10 Lock Lever FFC (Touch Pad SW-MAIN) FFC (Felica) Slide the lock lever upward to release the lock, and Slide the lock lever upward to release the lock, and disconnect the FFC (one place). disconnect the FFC (one place). FJ Series...
- Page 11 Open the LCD Section and disengage the detent (two places) from the rear side of the main unit with a bamboo spatula. Remove the Palmrest from the front side. * Push the detent lightly, and the detent is disengaged. FJ Series...
-
Page 12: Lcd Section
Camera Model FPC (ILINK-Main) Harness(Camera) Lock Lever Slide the lock lever upward to release the lock, and remove the FPC Pull out the Harness (one place). (one place). Harness(MIC) Harness(LCD) Disconnect the Harness (two places) by pulling it out. FJ Series... - Page 13 Remove the six screws, lift up the LCD Section with both hands, and remove the LCD Section. * Hold the LCD Section not to fall down. * The lug terminal is secured together with the Hinge (L) with a screw. FJ Series...
-
Page 14: Cooling Unit
1.MS-1-D.13 Confidential Cooling Unit Cooling Unit Harness Pull out the Harness (one place) upward. Remove the six screws in order. * These screws are built-in screws of the Cooling Unit. Cooling Unit Remove the Cooling Unit FJ Series... - Page 15 4 mm Release the lock by rotating the lock screw as shown in the picture. flat-head (-) screwdriver and release the lock. Remove the CPU vertically. * Be careful not to bend the pins. FJ Series...
- Page 16 * Remove it not to apply the excessive pressure to the Knob (Wireless). 2 [MA] 3 [MA] Screw: B1 Except 1st Model CNX Board Door (PCMCIA) Lens Polon Remove the two screws, and the Door (PCMCIA). Remove the Lens Polon (one place). FJ Series...
- Page 17 Screw: B1 FPC (ILING-Main) Lock Lever CNX Board Remove the one screw. Slide the lock lever upward to release the lock, and pull out the FPC upward. CNX Board Remove the CNX Board in the direction of the arrow. FJ Series...
-
Page 18: Mother Board
Peel off the Kapton Tape (one place). Remove the screw and the Bracket. 1 [ADD] DC Jack Screw:B1 Bracket (KENSINGTON) DC Jack Foil Remove the two screws, and the Bracket. Peel off the DC Jack Foil (one place), and remove the DC Jack. FJ Series... - Page 19 Raise the Mother Board from the right side, and remove it in the direction of the arrow. Remove the six screws. *Be careful not to apply the excessive pressure to the connector portions. * The Bracket is secured together with the Mother Board. FJ Series...
- Page 20 1.MS-1-D.19 Confidential Mother Board-3 Bracket (VGA) Remove the Bracket in the direction of the arrow. FJ Series...
- Page 21 FPC (Audio-Main) ANL Board ANL Board Housing (Bottom) Lock Lever While releasing the connector portion, remove the ANL Raise the lock lever upward to release the lock, and disconnect Board in the direction of the arrow. the FPC upward. FJ Series...
- Page 22 Peel off the Mylar (two place). *1: Above two figures show the same parts from another angle. Screw: B1 Screw: B6 Plate (Hinge Under-L) Plate (Hinge Under-R) Remove the two screws, and the Plate (two places). Remove the two screws. FJ Series...
- Page 23 1.MS-1-D.22 Confidential Parts of the Housing (Bottom)-2 Door (PR) PR Door Holder Remove the PR Door Holder vertically. Remove the Door (PR) vertically. 2 [ADD] Mylar Peel off the Mylar (one place). FJ Series...
- Page 24 2 [DEL] [CHG] Cushion Peel off the Mylar (one places). 2 [DEL] * There are Cushions (two places) under the Mylar. 2 [ADD] 5 [ADD] Mylar Peel off the Mylar (four places). Peel off the Foot (four places). FJ Series...
- Page 25 Remove the three screws. Remove the Cover (Housing Front) toward the front side. Knob (Wireless) Knob (Wireless) Cover (Housing Front) Disengage the detent (three places) from the backside of the Cover. Remove the Knob (Wireless) in the direction of the arrow. FJ Series...
-
Page 26: Update History
[DEL] Attachment (Page 22) [MA] (Page 15) 2006.02.03 2.10 [ADD] Attachment (Page 21) 2006.02.16 [CHG] Screw (Page 8) 2.20 2006.04.14 [ADD] Attachment (Page 23) 3.00 [MA] (Page 8) 2006.08.24 [DEL] Screw (Page 8) 4.00 [ADD] Screw (Page 8) FJ Series...