Related Manuals for Slide Clear Varro XL
Summary of Contents for Slide Clear Varro XL
- Page 1 Varro Retractable Pleated Screen XL Installation: Face-Mount Thank you for purchasing a Slide Clear Pleated Screen System Please read the instructions thoroughly before installing your new screen system.
-
Page 2: Required Tools And Materials
Required Tools and Materials Parts List Screwdriver and Screw bits ü Description Drawing Reference -Phillips #2 Top Track -Robertson #1 Jamb Profile Screw gun and drill ü Pull-Bar Carpenters level or laser level ü Base-Jamb Mount Straight edge ü Pencil ü... -
Page 3: Installation
Installation Ensure the Installation location is level and clean Install the Face Mount Option - Parts: N, O & P Pre-drill the countersunk groove on the face mount extrusion, every 2’ (610mm) ü Assemble the face-mount frame using the three face-mount profiles and the two face-mount corner keys ü... - Page 4 Install the Bottom Guide - Part: F Clean the bottom surface using a degreaser or alcohol based cleaner ü Align the bottom guide with the anchor plates, jamb profile and top track ü Temporarily position the bottom guide to ensure proper fitment, the bottom guide should fit under the magnet ü...
-
Page 5: Troubleshooting
The top track will equal the total width of the rough opening. The bottom guide will equal the total width of the rough opening less 3/4” (20mm). Note: Every Slide Clear pleated screen is manufactured to close 1/2” (12.7mm) past the total width of your opening. Revised: May-4-2016... - Page 6 13. Double check the magnet holder is completely snapped into the pull-bar. 14. Fully extend and retract the screen system to ensure a smooth operation. If your screen requires further adjustment beyond these instructions please visit www.slideclear.com/screens or contact the nearest Slide Clear service center for more information. Revised: May-4-2016...
-
Page 7: Year Limited Warranty
Slide Clear, in its sole discretion, may choose to repair the Product as an option to replacement in full satisfaction of its warranty obligation. -
Page 8: Care And Maintenance
(3) miles/five (5) kilometers of a seacoast or salt water), the standard or custom 2604 aluminum paint finish will be Warranted for a period of one (1) year. Anodized finishes are Warranted for a period of three (3) years unless the Slide Clear Inc. product has been operated and/or installed in a coastal environment (within three (3) miles/five (5) kilometers of a seacoast or salt water), the anodized finish will be Warranted for a period of one (1) year.