Table of Contents
Advertisement
English (GB) Installation and operating instructions
Original installation and operating instructions
These installation and operating instructions describe PC Tool
Link adapter and PC Tool Link software.
Sections 1-3 give the information necessary to be able to install
and start up the products in a safe way.
Sections 4-8 give important information about operating the
setup, as well as information about status LEDs, connecting
cables, fault finding and disposal of the product.
CONTENTS
1.
2.
3.
4.
5.
6.
7.
8.
Read this document before installing the product.
Installation and operation must comply with local
regulations and accepted codes of good practice.
1. General information
1.1 Hazard statements
The symbols and hazard statements below may appear in
Grundfos installation and operating instructions, safety
instructions and service instructions.
DANGER
Indicates a hazardous situation which, if not avoided,
will result in death or serious personal injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious personal injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate personal injury.
The hazard statements are structured in the following way:
SIGNAL WORD
Description of hazard
Consequence of ignoring the warning.
- Action to avoid the hazard.
2
1.2 Notes
The symbols and notes below may appear in Grundfos
installation and operating instructions, safety instructions and
service instructions.
Observe these instructions for explosion-proof
products.
Page
A blue or grey circle with a white graphical symbol
indicates that an action must be taken.
2
2
2
A red or grey circle with a diagonal bar, possibly with
2
a black graphical symbol, indicates that an action
2
must not be taken or must be stopped.
3
3
3
3
If these instructions are not observed, it may result in
malfunction or damage to the equipment.
3
4
5
7
Tips and advice that make the work easier.
8
8
2. Product description
Grundfos PC Tool Link is a communication adapter that can
connect all Grundfos products with a built-in communication
interface to a PC with a product-specific Grundfos PC Tool
software installed.
Grundfos PC Tool Link is the third generation of Grundfos
communication adapters.
PC Tool Link does not support powerline
communication. Use Powerline PC Tool Link USB
(97655367) instead.
PC Tool Link ensures galvanic separation between
the PC and the product connected. The risk of
damage in case of potential difference between the
connected units is also eliminated.
2.1 PC Tool Link package
The PC Tool Link package includes all the items needed to
connect the Grundfos product and the PC.
The setup.exe file can be downloaded from
www.ftdichip.com/Drivers/VCP.htm (select a VCP
driver for device "FT232R").
The PC Tool Link suitcase contains:
•
PC Tool Link
•
standard USB cable
•
TTL cable
•
RS-485 cable
•
adapter
•
printed version of installation and operating instructions.
- Quick Links:
- Fault Finding
Hide quick links:
Advertisement
Table of Contents
