To Remove The Battery Pack; To Replace The Battery Pack - Boosted S2 Quick Start Manual

To Remove the Battery Pack

15
• First ensure that the board is turned off.
• Place the board upside down on a flat surface. Using a 4mm hex
wrench, remove the six bolts fastening the battery pack to the deck.
• Lift the battery pack to reveal the connector between the deck and
battery pack.
• Carefully twist and pull the connector apart.

To Replace the Battery Pack

16
• To insert a new battery pack, align the grooves on both ends of the
connector (board & battery pack).
• Insert, push together, and twist the two ends of the connector
together. Make sure to tighten the connector fully to make a
good seal.
• Ensure the connector lays flat within the groove of the board side
by side with the accessory wire.
• Replace and tighten the bolts with the hex wrench.