Installation; Plates; Dimensions; Location - Techno Block AT series Use And Maintenance Instructions

6 Installation

6.1 Plates

The unit is supplied with warning and attention plates as listed in the relevant table.

6.2 Dimensions

Mod. A
AT1 767
AT2 767
AT3 860
AT4 860

6.3 Location

6.4 Free room

When installing the unit leave enough free room to allow opening, correct use and easy maintenance in
safe conditions.
B
310 535
310 535
400 670
450 670
To obtain optimal operation of the unit act as follows:
A) Place the unit in a well ventilated room, far from heat sources.
B) Limit the number of door openings.
C) Make sure that the unit has good air supply and discharge.
D) Fit a drain line to the defrost water drain connection in the lower part of the unit.
Note: GM units are equipped with automatic evaporation of defrost water; drain is just
a precaution in case of troubles.
Solution 1
Solution 2
C D E F
485 845
785 845
760 1070
760 1120
Solution 3
Installation in a
coldroom with
more than one unit
G
40
40
50
50
18