Advertisement
Mounting sPeed
Control
Continued
Models With staMped Face
LOUVERS (B36, VB36 WOOD
BURNING UNITS)
1. Using pliers, bend two retaining tabs on speed
control bracket 90 degrees to front of bracket
(see Figure 9).
2. Mount speed control box by placing plastic
control shaft through bottom hole on speed
control bracket. Top screw head on control box
will fit inside top hole on bracket (see Figure
9). Secure speed control to bracket with lock
nut by pushing and turning lock nut with pliers
clockwise until it is tight against bracket.
Control Knob
Figure 9 - Attaching Speed Control to Firebox with Stamp Faced Louvers
(B36 and VB36 Models) Using Speed Control Bracket 109892-01
6
Firebox Face
Louver Panel
Control Shaft
Retaining Tab
Retaining
Tabs
www.desatech.com
3. Remove knockout plug from louver panel by
depressing top and bottom retaining clips (see
Figure 1, page 2).
4. Position speed control assembly over flange
on hearth pan by sliding bracket up between
the face and the flange, then down until the
control shaft is aligned with the opening in the
louver panel (see Figure 9).
5. Lock two retaining tabs onto lower louver
by pressing down on bracket assembly while
sliding control knob through rectangular open-
ing on louver and onto the control shaft (see
Figure 9).
Speed Control
Bracket with
Assembly
Hearth Pan
Flange
Speed
Control
Bracket
Control
Shaft
Screw Head
and Top Hole
on Bracket
Lock Nut
108998-01E
Advertisement
