Quuppa LD-7L Installation Manual & Safety Information page 8

Installing Quuppa LD­7L
1. Attach the Quuppa LD­7L to compatible VESA mounting bracket.
Use M6 bolts and assembly torque of 2 nM (max allowed torque is
2.5 nM).
2. Attach the VESA mounting bracket to the wall, ceiling, or mast.
3. Aim the Quuppa LD­7L towards the intended coverage area and
tighten all fasteners.
4. Connect the ethernet cable to the Quuppa LD­7L. Make sure the
other end of the ethernet cable is connected to a device
connected to Quuppa HAIP system.
WARNING: Always make sure that the installation surface or mast can carry the weight
of the equipment and possible wind loads before installation.
Not following general safety regulation can cause damage to objects or injuries to
people. Rely on qualified personnel for carrying out the installation of Quuppa LD­7L.
Suggested cable and connector for outdoor use
In case you are installing Quuppa LD­7L outdoors or to other humid
environments use an ethernet cable and an ethernet connector that are
designed for outdoor use. The ethernet socket of Quuppa LD­7L is
Conec 17­10020 and it accepts both bayonet and M28 threaded
waterproof Ethernet connectors from Conec, for example 17­100464.
In indoor environments normal Ethernet cable with RJ45­connector
(Modular 8P8C) can be connected directly to the waterproof socket in
Quuppa LD­7L.
8 Quuppa LD­7L Installation Guide and Safety Information © 2014 Quuppa