Page 1
Release Date: 2014 - 05 - 08 BMW Easy Access Seats Components Version Information Model Name BMW Easy Access Latest Firmware Date 2014 - 05 - 08 Manual Version Rev. 1.0 Manual Release Date 2014 - 05 - 08 Module...
Page 3
1) Remove the vent cover and monitor. 2) Specification of the monitor 8-pin connector < CAN HIGH & LOW > No.5-pin(Light Green/Orange) = CAN HIGH No.6-pin(Light Green) = CAN LOW < POWER & GND > No.1-pin(Red/Yellow) = 12V POWER No.3-pin(Brown) = GROUND(GND)
Page 4
3) Splice the ‘IN CAN H(No.3 / White) wire’ to 4) Splice the ‘IN CAN L(No.4 / Green) wire’ to ‘No.5 wire(Light Green/Orange)’ of the monitor 8-pin connector. ‘No.6 wire(Light Green)’ of the monitor 8-pin connector. < CAN HIGH connection > <...
Page 5
5) Splice the ‘BAT +(No.1 / Yellow) wire’ to 6) Splice the ‘GROUND(No.2 / Black) wire’ to ‘No.1 wire(Red/Yellow)’ of the monitor 8-pin connector. ‘No.3 wire(Brown)’ of the monitor 8-pin connector. < POWER connection > < GROUND connection >...
Page 6
7) 4 wires should be spliced with each wires of monitor connector. 8) Set the DIP switch for BMW 5 Series(F10 / 4-Pin LVDS).
Page 7
9) Red LED light will be turned on after connect the cable. 10) Driver’s seat is moved to the memory position No.1(ⓐ) automatically, when you turn on the ignition. The seat is moved back to the memory position No.2(ⓑ), when you turn off the ignition.