LDI Spaces Safco 4081R Assembly Instructions

an LDI Spaces Company
Minneapolis, MN 55428
www.safcoproducts.com
FOOT PLATE INSTALLATION
SMALL
WASHER
SMALL
LOCK NUT
WHEEL INSTALLATION
AXLE PLATE HOLE "A"
AXLE PLATE HOLE "B"
CASTER, HANDLE INSTALLATION –
LARGE LOCK
NUT
CASTER
If not pre-installed, insert stem of caster
through hole (as shown) then fasten with
large lock nut.
100408137: 1 of 3; Rev A; Rev Date 01-AUG-2016
HAND TRUCKS
A S S E M B L Y
PRODUCT WARRANTY is available online at: www.safcoproducts.com
FRAME
AXLE PLATE
LARGE
WASHER
AXLE
MODEL NO. 4086R AND NO. 4087R ONLY
For handle adjustment: line up any handle hole
to frame hole. "A" is standard, "B" is extended.
Use clip to lock in desired position. NOTE: insert
clip with exposed portion down.
INSTRUCTIONS
Align holes in base of frame with square holes in foot plate.
Secure with carriage bolts, small washers and small lock
nuts as shown.
FRAME
FOOT PLATE
CARRIAGE BOLTS
FOR 10-INCH WHEELS: (Model No. 4084R and

No. 4086R) Slide axle through hole "A" in axle plates.
FOR 8-INCH WHEELS: Slide axle through hole "B"

in axle plates.
NOTE: If axle plate holes are too tight, scrape
excess paint from holes.
NEXT: Slide a large washer, a wheel (recessed side of

wheel hub facing out), and another large washer over
each end of axle.
LARGE
Insert cotter key through each axle hole and spread

WASHER
cotter key ends.
COTTER
KEY
"B"
"A"
Safco Consumer Hot Line
available Monday-Friday 7:30 AM to 5:00 PM (Central Time) (English-speaking operators)
4081R, 4084R, 4086R,
4087R, 4092
HANDLE
CLIP
PLATFORM
SUPPORT
For handle in platform position: remove handle
from frame assembly. Reposition handle in
platform supports and insert clips.
1-800-664-0042
Safco Products Company, New Hope, MN 55428