Challenger SmartForce ASFFOB Installation And Operating Instructions page 2

OPERATING THE REMOTE CONTROL
1.
Pressing the Arm button will control the control panel to enter the arm mode.
2.
Pressing the Disarm button will control the control panel to enter the disarm
mode.
3.
Pressing the Partial Arm button will control the control panel to enter the
part-arm 1.
4.
By sliding the panic switch will activate the control panel to initiate a full alarm
condition.
TESTING THE REMOTE CONTROL
The operation of the Remote Control should be tested with the system in normal
mode to ensure that the new Remote Control will successfully communicate with
the system and the Arm and Disarm functions operate correctly. Also check by
activating the Panic switch on the Remote to initiate an alarm condition.
Refer to your System Installation and Operating Manual for further details on
operating and testing the system.
SPECIFICATIONS
Battery Type CR2032 3V/230mAhr
Operating Frequency 868MHz
Due to our policy of continuous improvement we reserve the right to change
specification without prior notice.
Errors and omissions excepted. These instructions have been carefully checked
prior to publication. However, no responsibility can be accepted by Challenger for
any misinterpretation of these instructions.
Challenger Security Products
10 Sandersons Way, Blackpool, FY4 4NB
Tel: 01253 791888, Fax: 01253 791887
Email: enquiries.challenger@adivision.co.uk
Web: www.challenger.co.uk
Challenger_ASFFOB_Instructions_Rev01