Rowe BC1400 Update Instructions

Validator Update Instructions for Rowe BC1400 $1 - $5
Kit Overview
The purpose of the kit is to replace the Rowe BA50 transport and stacker with a 120 volt
Mars validator with a compact mask.
The kit and these instructions pertain to a Rowe BC1400,
There are 2 variations of the kit, one will
this is a rear-loading changer with two hoppers.
process $1-$5 and the second $1-$20. This kit is designed for dollar bill changers that are
not used to make change for a coin. If you are accepting coins please, contact us for a coin
interface kit. This stock kit will work in changers with board numbers 65069006 and
65069050.
The kit will work with all 3 variations of the Rowe BILL CHANGER CONTROL COMPUTER
boards; 65069001, 65069006, and 65069050. The E prom in board versions 6509006 and
6509050 will be changed to 2.7.
If you are installing the kit with board number 65069001 two additional parts are needed.
This is the early style obsolete board. Please call us prior to beginning the conversion so
they can be sent to you. The parts kit includes a E prom and a transport by-pass harness.
Order part number KITCVR65069001-Eprom costing $10.00. We can be reached at Capital
Vending 800 814-7756.
The installation information is intended for experienced personnel familiar with the operation
of these components. All of the installation procedures must be reviewed and understood
prior to installing the kit. The installation instructions are based upon a dollar bill changer
that has not been modified from the original factory configuration. If the machine has been
altered in any way, restore the machine to the original factory configuration prior to
beginning the conversion. The installer must know the proper procedures to replace an E
prom.
Kit Components
The kit contains the following parts:
labeled BC1200/1400/3500
Module in black plastic box;
Metal validator slide plate for rear loading changer; flange on rear
E prom with label BC3500 V2.7
One "low coins" screws and harness
Additional Required Items Not Included With Kit
Working Mars validator – Model AE2411/AE2451, VN2511, or AE2611
The four 11-32 hex nuts used to mount the Mars validator to the validator slide plate are
included in the Mars validator shipping box.
Dollar bills to test the validator and verify operation of the kit
Tools Required
11/32", ¼", and 3/8" long handle nut drivers
Pliers
Small screwdriver or IC removal tool
Optional Tools Required for "low coins" screw installation
Drill
5/16" drill bit
Page 1