Dish Network Over-the-Air Antenna Instruction Sheet

CONNECT YOUR OTA ANTENNA TO YOUR RECEIVER
Attach the coax cable from your
OTA antenna to the coax port on
your OTA adapter.
Turn your television and receiver
on. Then, open the Menu for your
receiver.
Select "Scan Channels."
• This scan could take up to
five minutes to complete.
When it is complete, you
will see a list of the OTA
channels that your antenna
found.
CONNECT YOUR OTA ANTENNA TO YOUR TV
Turn your TV on, and take note of
the channel or input that it is on.
Using the buttons on your TV, or
your TV remote, press the Menu/
Settings,/Home button.
Select Scan Channels/Program
Channels/Autoscan/Autoprogram.
Go to mydish.com/ota for details on setting up your OTA antenna
Give us a call at 1-800-333-DISH (3474)
Connect the USB end of your OTA
adapter to the USB port on your DISH
receiver.
Select "System Setup" on your screen,
and then select "Local Channels."
When the popup appears, select "OK"
and then select "Done."
Connect your antenna to your TV's
Antenna In/Air/Cable port.
Select Channel/Setup/Auto Tuning/
Installation/System.
Select Start/Enter/OK to start scanning
and adding channels to your TV's
channel lineup. Select OK/Done to
complete your scan.
Got Questions?
OR
• If your TV requires a conversion
box, connect your antenna to
the conversion box, and then
connect the box to the TV.
• If you are prompted to select Air
or Cable, select Air.