Goodlife BarkWise Complete Instruction Manual

BarkWise™ Complete
Included In Your Package
BarkWise™ Complete
AC Adapter
Nylon Strap
Remote Control
Getting Started
1. Charge it Up
Before getting started, charge your BarkWise™ for at least
2 hours. The blue LED will light up and remain on while
charging. Battery life lasts 12–24 hours depending on use.
Charge nightly for best results. This will also give your dog a
break from daily training.
2. Set the Bark Sensor
The bark sensitivity slider adjusts the unit's sensitivity to your dog's bark. Start by
setting the bark sensitivity slider to low. We recommend setting the slider above
the R in "BARK". If the sensor is too high, the collar might activate too often which
can stress the dog and hinder training.
NOTE: Only raise the sensitivity level if the unit isn't responding to your dog's barking.
Be sure to give your dog time to acclimate to the collar. We recommend waiting 2–3
weeks before adjusting the settings.
3. Choose Your Training Type(s)
Control Panel Configuration
BarkWise™ offers a combination of sound, vibration,
and remote control training. This is where you'll choose
the options for your dog's unique needs.
Many people like to start with an "UP-UP-DOWN"
configuration, as highlighted in the diagram in the
upper right corner of the page.
If you want to start with remote-only training, set
your switches to: DOWN-DOWN-DOWN.
NOTE: If you need help deciding, just give us a call or
send us a message. All contact info is at the end of this
guide.
Instruction Manual
Configuration Options
Setting
(up)
(down)
BarkWise Control Panel
™
Power Jack
Bark Sensitivity Slider
-
BARK SENSITIVITY
REM
(Remote)
Auto bark
Ultrasonic sound
detection ON
Remote activation
Audible sound OFF
ON
Auto bark
Ultrasonic sound
detection OFF
Remote activation
Audible sound ON
ON
Settings Control Panel
+
AUD VIB
(Audio) (Vibration)
ON Vibration OFF
ON
Vibration ON