Redkite Sit Me Up Instruction Leaflet

IMPORTANT!
KEEP FOR FUTURE REFERENCE
Read these instructions carefully before use.
Your child' s safety may be affected if you do not follow these instructions.
Instruction leaflet
Sit Me Up
Fabric cover
Inner tube inside
(not shown)
Tray
attachment
point
(with Velcro)
This product complies with EN 71
Suitable from 9 months
For all technical queries please call: 01454 326 568
Imported by:
The Red Kite Baby Co Ltd, 35 Lavenham Road,
Beeches Industrial Estate, Yate, Bristol, BS37 5QX. UK
INSTRUCTIONS
1.
2.
3.
4.
SAFETY WARNINGS
• KEEP AWAY FROM FIRE!
• Minimum recommended age for use - 9 months.
• Do not use until your baby is fully able to support its head and sit up
unaided.
• Only use this product under full adult supervision.
• Do not leave a child unattended in this product. Always keep your child
in view.
• Position the Sit Me Up on a level and stable floor surface.
Additional
fun links for
• Keep the Sit Me Up away from trailing cords and flexes.
baby' s
• Do not use for more than one child at a time.
favourite
toy • Your child' s safety is your responsibility.
• Be aware of the risk of open fire and other sources of strong heat, such
Tray as electric bar fires, gas fires, etc. in the near vicinity of the Sit Me Up.
attachment
• Keep the Sit Me Up away from sharp objects.
point
(with Velcro) • Do not carry a baby in the Sit Me Up.
• Check the inflatable ring and fabric cover for signs of damage.
• Stop using the Sit Me Up if you notice any signs of damage and or
deterioration.
Val v e
(on inner tube • This product must not be used as a car seat, in a bath (or in any
under fabric cover)
water).
• This product is a toy and must not be used as a support or restraint
system or for any other purpose than supervised play.
• Adult assembly required.
WASHING INSTRUCTIONS
• Cover: Surface wash only with a mild detergent solution. Air dry. Do
not bleach. Do not iron. Do not tumble dry. Do not dry clean.
• Inner tube: Surface clean with a mild detergent solution only. Air dry.
Do not bleach. Do not iron. Do not tumble dry. Do not dry clean.
Fully unfold the fabric cover.
Place the inner tube inside the fabric cover (if not already inside the cover).
Inflate the inner tube by taking the stopper out of the valve and pulling the valve out
of the tube by approx 2cm. Squeeze the base of the valve and blow into
the opening. Replace stopper and push back down so that it is level with the tube.
Attach the tray to the Velcro located on both sides of the seat.