Subscribe to Our Youtube Channel
Related Manuals for DIGI-STAR AutoLog GT460
Summary of Contents for DIGI-STAR AutoLog GT460
- Page 1 Rotation Counter Installation Manual Ft. Atkinson, Wisconsin USA Panningen, The Netherlands www.digi-star.com D3908-US Rev A August 16, 2011...
- Page 2 Installation Manual INTRODUCTION Thank you for upgrading your scale indicator for use with the grain cart AutoLog feature. With this feature, the rotation counter sensor allows for the indicator to count the number of revolutions of the PTO shaft which in turn allows the unit to “Automatically Log”...
- Page 3 Installation Manual CONTENTS 1. Cable- RC Sensor “Y” (PN: 407201) 2. Cable- RC Sensor 16 Foot Extension (PN: 407200) 3. Sensor- Rotation Counter with Connector (PN: 407199) 4. Target- Square Tubing with Adhesive (PN: 407419) 5. Clamp- Hose Size 24 SS (PN: 407451) 6.
- Page 4 Installation Manual INSTALLATION INSTRUCTIONS 1. Clean PTO shaft with wire brush where applying target and wipe down with cleaning agent. 2. Peel off adhesive backing on target. 3. Attach target, adhesive side down, securely to PTO shaft with hose clamp as shown in Figure 2. Place hose clamp screw head inside target as shown in Figures 2 and 3.
- Page 5 Installation Manual 4. Attach Rotation Counter Sensor Mounting Bracket to grain cart as shown in Figure 2. 5. Adjust sensor to 1/8” (3mm) from target as shown in Figure 3. Rotation Counter Status LED 0.125 Inch (3mm) Sensor - Target Rotation Counter Sensor Mounting Bracket Rotation Counter Sensor...
- Page 6 Installation Manual TESTING THE SYSTEM 1. With power applied, the Rotation Counter Status LED as shown in Figure 3 will turn “On” when it senses the steel target. 2. If sensor LED is constantly “On”, move sensor from target slightly. The target should light sensor LED only when PTO is spinning or when target is directly in line with sensor as shown in Figure 3.
Need help?
Do you have a question about the AutoLog GT460 and is the answer not in the manual?
Questions and answers